Reference Guide

Term Definition
ISDP IP Address Table Full
Displays the number of times a neighbor entry was added to the table
without an IP address.
The following example shows CLI display output for the command.
(Extreme 220) (Routing) #show isdp traffic
ISDP Packets Received.......................... 4253
ISDP Packets Transmitted....................... 127
ISDPv1 Packets Received........................ 0
ISDPv1 Packets Transmitted..................... 0
ISDPv2 Packets Received........................ 4253
ISDPv2 Packets Transmitted..................... 4351
ISDP Bad Header................................ 0
ISDP Checksum Error............................ 0
ISDP Transmission Failure...................... 0
ISDP Invalid Format............................ 0
ISDP Table Full................................ 392
ISDP IP Address Table Full..................... 737
debug isdp packet
This command enables tracing of ISDP packets processed by the switch. ISDP must be enabled on both
the device and the interface in order to monitor packets for a particular interface.
Format
debug isdp packet [{receive | transmit}]
Mode Privileged EXEC
no debug isdp packet
This command disables tracing of ISDP packets on the receive or the transmit sides or on both sides.
Format
no debug isdp packet [{receive | transmit}]
Mode Privileged EXEC
Interface Error Disable and Auto Recovery
Interface error disable automatically disables an interface when an error is detected; no trac is allowed
until the interface is either manually re-enabled or, if auto recovery is configured, the configured auto
recovery time interval has passed.
For interface error disable and auto recovery, an error condition is detected for an interface, the
interface is placed in a diagnostic disabled state by shutting down the interface. The error disabled
interface does not allow any trac until the interface is re-enabled. The error disabled interface can be
manually enabled. Alternatively administrator can enable auto recovery feature. 200 Series Auto
Recovery re-enables the interface after the expiry of configured time interval.
Switching Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 492