Reference Guide

Format show telnetcon
Modes
•
Privileged EXEC
•
User EXEC
Column Meaning
Remote Connection Login
Timeout (minutes)
This object indicates the number of minutes a remote connection session is
allowed to remain inactive before being logged o. May be specified as a number
from 1 to 160. The factory default is 5.
Maximum Number of Remote
Connection Sessions
This object indicates the number of simultaneous remote connection sessions
allowed. The factory default is 5.
Allow New Telnet Sessions New Telnet sessions will not be allowed when this field is set to no. The factory
default value is yes.
Telnet Server Admin Mode If Telnet Admin mode is enabled or disabled.
Telnet Server Port The configured TCP port number on which the Telnet server listens for requests.
(The default is 23.)
Secure Shell Commands
This section describes the commands used to configure Secure Shell (SSH) access to the switch. Use
SSH to access the switch from a remote management host.
Note
The system allows a maximum of five SSH sessions.
ip ssh
Use this command to enable SSH access to the system. (This command is the short form of the ip ssh
server enable command.)
Default
Disabled
Format ip ssh
Mode Privileged EXEC
ip ssh port
Use this command to configure the TCP port number on which the SSH server listens for requests. Valid
port numbers are from 1–65535.
Default
22
Format ip ssh port 1-65535
Mode Privileged EXEC
Management Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 50