Reference Guide

optionally set the distance (preference) of an individual static route. The default distance is used when
no distance is specified in these commands. Changing the default distance does not update the
distance of existing static routes, even if they were assigned the original default distance. The new
default distance will only be applied to static routes created after invoking the ip route distance
command.
Default 1
Format ip route distance 1-255
Mode Global Config
no ip route distance
This command sets the default static route preference value in the router. Lower route preference values
are preferred when determining the best route.
Format no ip route distance
Mode Global Config
ip route net-prototype
This command adds net prototype IPv4 routes to the hardware.
Format
ip route net-prototype prefix/prefix-length nexthopip num-
routes
Mode Global Config
Parameter Description
prefix/
prefix-
length
The destination network and mask for the route.
nexthopip The next-hop ip address, It must belong to an active routing interface, but it does not need to
be resolved.
num-routes The number of routes need to added into hardware starting from the given prefix argument
and within the given prefix-length.
no ip route net-prototype
This command deletes all the net prototype IPv4 routes added to the hardware.
Format
ip route net-prototype prefix/prefix-length nexthopip num-
routes
Mode Global Config
Routing Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 511