Reference Guide

Default none
Format ip rip authentication {none | {simple key} | {encrypt key
keyid}}
Mode Interface Config
no ip rip authentication
This command sets the default RIP Version 2 Authentication Type for an interface.
Format no ip rip authentication
Mode Interface Config
ip rip receive version
This command configures an interface or range of interfaces to allow RIP control packets of the
specified version(s) to be received.
The value for mode is one of: rip1 to receive only RIP version 1 formatted packets, rip2 for RIP version 2,
both to receive packets from either format, or none to not allow any RIP control packets to be received.
Default
both
Format ip rip receive version {rip1 | rip2 | both | none}
Mode Interface Config
no ip rip receive version
This command configures the interface to allow RIP control packets of the default version(s) to be
received.
Format
no ip rip receive version
Mode Interface Config
ip rip send version
This command configures an interface or range of interfaces to allow RIP control packets of the
specified version to be sent. The value for mode is one of: rip1 to broadcast RIP version 1 formatted
packets, rip1c (RIP version 1 compatibility mode) which sends RIP version 2 formatted packets via
broadcast, rip2 for sending RIP version 2 using multicast, or none to not allow any RIP control packets
to be sent.
Default
rip2
Format ip rip send version {rip1 | rip1c | rip2 | none}
Mode Interface Config
Routing Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 568