Reference Guide

7 IPv6 Management Commands
IPv6 Management Commands
Loopback Interface Commands
IPv6 Routing Commands
DHCPv6 Snooping Configuration Commands
This chapter describes the IPv6 commands available in the 200 Series CLI.
Caution
The commands in this chapter are in one of three functional groups:
•
Show commands display switch settings, statistics, and other information.
•
Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
•
Clear commands clear some or all of the settings to factory defaults.
IPv6 Management Commands
IPv6 Management commands allow a device to be managed via an IPv6 address in a switch or IPv4
routing (that is, independent from the IPv6 Routing package). For Routing/IPv6 builds of 200 Series
dual IPv4/IPv6 operation over the service port is enabled. 200 Series has capabilities such as:
•
Static assignment of IPv6 addresses and gateways for the service/network ports.
•
The ability to ping an IPv6 link-local address over the service/network port.
•
Using IPv6 Management commands, you can send SNMP (Simple Network Management Protocol)
traps and queries via the service/network port.
•
The user can manage a device via the network port (in addition to a Routing Interface or the Service
port).
serviceport ipv6 enable
Use this command to enable IPv6 operation on the service port. By default, IPv6 operation is enabled
on the service port.
Default
Enabled
Format serviceport ipv6 enable
Mode Privileged EXEC
no serviceport ipv6 enable
Use this command to disable IPv6 operation on the service port.
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 573