Reference Guide

Format no serviceport ipv6 enable
Mode Privileged EXEC
network ipv6 enable
Use this command to enable IPv6 operation on the network port. By default, IPv6 operation is enabled
on the network port.
Default Enabled
Format network ipv6 enable
Mode Privileged EXEC
no network ipv6 enable
Use this command to disable IPv6 operation on the network port.
Format no network ipv6 enable
Mode Privileged EXEC
serviceport ipv6 address
Use this command to manually configure IPv6 global address, enable/disable stateless global address
autoconfiguration and to enable/disable dhcpv6 client protocol information on the service port.
Note
Multiple IPv6 prefixes can be configured on the service port.
Format serviceport ipv6 address {address/prefix-length [eui64]|
autoconfig|dhcp}
Mode Privileged EXEC
Parameter Description
address
IPv6 prefix in IPv6 global address format.
prefix-length
IPv6 prefix length value.
eui64 Formulate IPv6 address in eui64 address format.
autoconfig Configure stateless global address autoconfiguration capability.
dhcp Configure dhcpv6 client protocol.
no serviceport ipv6 address
Use the command no serviceport ipv6 address to remove all configured IPv6 prefixes on the service
port interface.
IPv6 Management Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 574