Reference Guide

Format no network ipv6 address {address/prefix-length [eui64] |
autoconfig | dhcp}
Mode Privileged EXEC
network ipv6 gateway
Use this command to configure IPv6 gateway (that is, default routers) information for the network port.
Format network ipv6 gateway gateway-address
Mode Privileged EXEC
Parameter Description
gateway-
address
Gateway address in IPv6 global or link-local address format.
no network ipv6 gateway
Use this command to remove IPv6 gateways on the network port interface.
Format
no network ipv6 gateway
Mode Privileged EXEC
network ipv6 neighbor
Use this command to manually add IPv6 neighbors to the IPv6 neighbor table for this network port. If
an IPv6 neighbor already exists in the neighbor table, the entry is automatically converted to a static
entry. Static entries are not modified by the neighbor discovery process. They are, however, treated the
same for IPv6 forwarding. Static IPv6 neighbor entries are applied to the kernel stack and to the
hardware when the corresponding interface is operationally active.
Format
network ipv6 neighbor ipv6-address macaddr
Mode Privileged EXEC
Parameter Description
ipv6-address
The IPv6 address of the neighbor or interface.
macaddr
The link-layer address.
no network ipv6 neighbor
Use this command to remove IPv6 neighbors from the neighbor table.
IPv6 Management Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 577