Reference Guide

To specify the match condition using a numeric value notation, the protocol number is a standard value
assigned by IANA and is interpreted as an integer from 0 to 255. Use the [not] option to negate the
match condition.
Note
This command does not validate the protocol number value against the current list defined by
IANA.
Default None
Format match [not] protocol {protocol-name | 0-255}
Mode Class-Map Config
Ipv6-Class-Map Config
match signature
This command maps the available signatures from the rules file to the AppIQ class. When the appiq
class is created, this menu displays an index number and its signature pattern. A single signature can be
mapped using a number or multiple signatures can be selected and mapped to a class. Using this
command without an index value maps all the available signatures to the same class.
Default
None
Format match signature [StartIndex-EndIndex]
Mode Class-Map Config
match srcip
This command adds to the specified class definition a match condition based on the source IP address
of a packet. The ipaddr parameter specifies an IP address. The ipmask parameter specifies an IP address
bit mask and must consist of a contiguous set of leading 1 bits. Use the [not] option to negate the
match condition.
Default
None
Format match [not] srcip ipaddr ipmask
Mode Class-Map Config
match srcip6
This command adds to the specified class definition a match condition based on the source IP address
of a packet. Use the [not] option to negate the match condition.
Default
None
Format match [not] srcip6 source-ipv6-prefix/prefix-length
Mode Ipv6-Class-Map Config
Quality of Service Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 605