Reference Guide

Format no access-list accesslistnumber [rule 1-1023]
Mode Global Config
ip access-list
This command creates an extended IP ACL identified by name, consisting of classification fields defined
for the IP header of an IPv4 frame. The name parameter is a case-sensitive alphanumeric string from 1
to 31 characters uniquely identifying the IP access list. The rate-limit attribute configures the committed
rate and the committed burst size.
If an IP ACL by this name already exists, this command enters IPv4-Access_List config mode to allow
updating the existing IP ACL.
Note
The CLI mode changes to IPv4-Access-List Config mode when you successfully execute this
command.
Format ip access-list name
Mode Global Config
no ip access-list
This command deletes the IP ACL identified by name from the system.
Format
no ip access-list name
Mode Global Config
ip access-list rename
This command changes the name of an IP ACL. The name parameter is the names of an existing IP ACL.
The newname parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely
identifying the IP access list.
This command fails is an IP ACL by the name newname already exists.
Format
ip access-list rename name newname
Mode Global Config
ip access-list resequence
Use this command to renumber the sequence numbers of the entries for specified IP access list with the
given increment value starting from a particular sequence number. The command is used to edit the
Quality of Service Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 631