Reference Guide

Parameter Description
cpu-sharing
0-99
Sets the CPU share allocated to this application, expressed as a percentage between 0 and
99. If 0 is specified, the application process(es) are not limited. If this keyword is not specified,
the default value of 0 is used.
max-
megabytes
0-200
Sets the maximum memory resource that the application process(es) can consume.
Expressed as megabytes between 0 and 200. If 0 is specified, the application process(es) are
not limited. If this keyword is not specified, the default value of 0 is used.
To start an installed application, use the application start on page 662 command.
no application install
This command removes the configuration of an application for execution on the switch. If the
application is running, all processes associated with the application are stopped automatically.
Format no application install filename
Mode Global Config
For example, to remove the ExtremeCloud application, issue the command:
(Extreme 220) (Config) #no application install connector.pyz
application start
This command starts the execution of the specified application. Before an application can be started, it
must first be installed using the application install on page 661 command. (Exception: the ExtremeCloud
application, connector.pyz, is pre-installed on your 200 Series switch.)
Format
application start filename
Mode Privileged EXEC
application stop
This command stops the execution of the specified application.
Format
application stop filename
Mode Privileged EXEC
show application
This command displays the installed applications and their parameters.
Format
show application filename
Mode Privileged EXEC
Application Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 662