Reference Guide

Table 38: Mac-based VLANs Log Messages (continued)
Component Message Cause
MAC based
VLANs
vlanMacCnfgrFiniPhase1Process: could not
delete avl semaphore
This appears when a semaphore deletion of
this component fails.
MAC based
VLANs
vlanMacAddApply: Failed to add an entry This appears when a dtl call fails to add an
entry into the table.
MAC based
VLANs
vlanMacDeleteApply: Unable to delete an
Entry
This appears when a dtl fails to delete an
entry from the table.
MAC based
VLANs
vlanMacVlanChangeCallback: Failed to add an
entry
This appears when a dtl fails to add an entry
for a vlan add notify event.
MAC based
VLANs
vlanMacVlanChangeCallback: Failed to delete
an entry
This appears when a dtl fails to delete an
entry for an vlan delete notify event.
Table 39: 802.1X Log Messages
Component Message Cause
802.1X function: Failed calling dot1xIssueCmd 802.1X message queue is full.
802.1X function: EAP message not received from
server
RADIUS server did not send required EAP
message.
802.1X function: Out of System buers 802.1X cannot process/transmit message due
to lack of internal buers.
802.1X function: could not set state to
authorized/unauthorized, intf xxx
DTL call failed setting authorization state of
the port.
802.1X dot1xApplyConfigData: Unable to enable/
disable dot1x in driver
DTL call failed enabling/disabling 802.1X.
802.1X dot1xSendRespToServer:
dot1xRadiusAccessRequestSend failed
Failed sending message to RADIUS server.
802.1X dot1xRadiusAcceptProcess: error calling
radiusAccountingStart, ifIndex = xxx
Failed sending accounting start to RADIUS
server.
802.1X function: failed sending terminate cause, intf
xxx
Failed sending accounting stop to RADIUS
server.
Table 40: IGMP Snooping Log Messages
Component Message Cause
IGMP (Internet
Group
Management
Protocol)
Snooping
function: osapiMessageSend failed IGMP Snooping message queue is full.
IGMP Snooping Failed to set global igmp snooping mode to
xxx
Failed to set global IGMP Snooping mode due
to message queue being full.
IGMP Snooping Failed to set igmp snooping mode xxx for
interface yyy
Failed to set interface IGMP Snooping mode
due to message queue being full.
200 Series Log Messages
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 674