Reference Guide

Table 40: IGMP Snooping Log Messages (continued)
Component Message Cause
IGMP Snooping Failed to set igmp mrouter mode xxx for
interface yyy
Failed to set interface multicast router mode
due to IGMP Snooping message queue being
full.
IGMP Snooping Failed to set igmp snooping mode xxx for vlan
yyy
Failed to set VLAN IGM Snooping mode due
to message queue being full.
IGMP Snooping Failed to set igmp mrouter mode%d for
interface xxx on Vlan yyy
Failed to set VLAN multicast router mode due
to IGMP Snooping message queue being full.
IGMP Snooping snoopCnfgrInitPhase1Process: Error allocating
small buers
Could not allocate buers for small IGMP
packets.
IGMP Snooping snoopCnfgrInitPhase1Process: Error allocating
large buers
Could not allocate buers for large IGMP
packets.
Table 41: GARP/GVRP/GMRP Log Messages
Component Message Cause
GARP/GVRP/
GMRP
garpSpanState, garpIfStateChange,
GarpIssueCmd, garpDot1sChangeCallBack,
garpApiCnfgrCommand,
garpLeaveAllTimerCallback,
garpTimerCallback: QUEUE SEND FAILURE:
The garpQueue is full, logs specifics of the
message content like internal interface
number, type of message, and so forth.
GARP/GVRP/
GMRP
GarpSendPDU: QUEUE SEND FAILURE The garpPduQueue is full, logs specific of the
GPDU, internal interface number, vlan id,
buer handle, and so forth.
GARP/GVRP/
GMRP
garpMapIntfIsConfigurable,
gmrpMapIntfIsConfigurable: Error accessing
GARP/GMRP config data for interface %d in
garpMapIntfIsConfigurable.
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no
preconfiguration.
GARP/GVRP/
GMRP
garpTraceMsgQueueUsage: garpQueue usage
has exceeded fifty/eighty/ninety percent
Traces the build up of message queue. Helpful
in determining the load on GARP.
GARP/GVRP/
GMRP
gid_destroy_port: Error Removing port %d
registration for vlan-mac %d - %02X:%02X:
%02X:%02X:%02X:%02X
Mismatch between the gmd (gmrp database)
and MFDB.
GARP/GVRP/
GMRP
gmd_create_entry: GMRP failure adding
MFDB entry: vlan %d and address %s
MFDB table is full.
Table 42: 802.3ad Log Messages
Component Message Cause
802.3ad dot3adReceiveMachine: received default
event %x
Received a LAG (Link Aggregation Group)
PDU and the RX state machine is ignoring this
LAGPDU.
802.3ad dot3adNimEventCompletionCallback,
dot3adNimEventCreateCompletionCallback:
DOT3AD: notification failed for event(%d),
intf(%d), reason(%d)
The event sent to NIM was not completed
successfully.
200 Series Log Messages
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 675