Reference Guide

Table 49: Port Mac Locking Log Message
Component Message Cause
Port Mac Locking pmlMapIntfIsConfigurable: Error accessing
PML config data for interface %d in
pmlMapIntfIsConfigurable.
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no
preconfiguration.
Table 50: Protocol-based VLANs Log Messages
Component Message Cause
Protocol Based
VLANs
pbVlanCnfgrInitPhase2Process: Unable to
register NIM callback
Appears when nimRegisterIntfChange fails to
register pbVlan for link state changes.
Protocol Based
VLANs
pbVlanCnfgrInitPhase2Process: Unable to
register pbVlan callback with VLANs
Appears when VLANRegisterForChange fails
to register pbVlan for VLAN changes.
Protocol Based
VLANs
pbVlanCnfgrInitPhase2Process: Unable to
register pbVlan callback with nvStore
Appears when nvStoreRegister fails to
register save and restore functions for
configuration save.
QoS
Table 51: ACL Log Messages
Component Message Cause
ACL (Access
Control List)
Total number of ACL rules (x) exceeds max
(y) on intf i.
The combination of all ACLs applied to an
interface has resulted in requiring more rules
than the platform supports.
ACL aclLogTask: error logging ACL rule trap for
correlator number
The system was unable to send an SNMP trap
for this ACL rule which contains a logging
attribute.
ACL IP ACL number: Forced truncation of one or
more rules during config migration
While processing the saved configuration, the
system encountered an ACL with more rules
than is supported by the current version. This
may happen when code is updated to a
version supporting fewer rules per ACL than
the previous version.
Table 52: CoS Log Message
Component Message Cause
COS cosCnfgrInitPhase3Process: Unable to apply
saved config -- using factory defaults
The CoS component was unable to apply the
saved configuration and has initialized to the
factory default settings.
200 Series Log Messages
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 679