Reference Guide

Table 53: DiServ Log Messages
Component Message Cause
DiServ diserv.c 165: diServRestore Failed to reset
DiServ. Recommend resetting device
While attempting to clear the running
configuration an error was encountered in
removing the current settings. This can lead to
an inconsistent state in the system. We
recommend rebooting the switch.
DiServ Policy invalid for service intf: policy name,
interface x, direction y
The DiServ policy definition is not
compatible with the capabilities of the
interface specified. Check the platform release
notes for information on configuration
limitations.
Routing/IPv6 Routing
Table 54: DHCP Relay Log Messages
Component Message Cause
DHCP relay REQUEST hops field more than config value The DHCP relay agent has processed a DHCP
request whose HOPS field is larger than the
maximum value allowed. The relay agent will
not forward a message with a hop count
greater than 4.
DHCP relay Request's seconds field less than the config
value
The DHCP relay agent has processed a DHCP
request whose SECS field is larger than the
configured minimum wait time allowed.
DHCP relay processDhcpPacket: invalid DHCP packet
type: %u\n
The DHCP relay agent has processed an
invalid DHCP packet. Such packets are
discarded by the relay agent.
Table 55: OSPFv2 Log Messages
Component Message Cause
OSPFv2 Best route client deregistration failed for
OSPF Redist
OSPFv2 registers with the IPv4 routing table
manager (“RTO”) to be notified of best route
changes. There are cases where OSPFv2
deregisters more than once, causing the
second deregistration to fail. The failure is
harmless.
OSPFv2 XX_Call() failure in _checkTimers for thread
0x869bcc0
An OSPFv2 timer has fired but the message
queue that holds the event has filled up. This
is normally a fatal error.
OSPFv2 Warning: OSPF LSDB is 90% full (22648
LSAs).
OSPFv2 limits the number of Link State
Advertisements (LSAs) that can be stored in
the link state database (LSDB). When the
database becomes 90 or 95 percent full,
OSPFv2 logs this warning. The warning
includes the current size of the database.
200 Series Log Messages
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 680