Reference Guide

Stacking
Table 61: EDB Log Message
Component Message Cause
EDB EDB Callback: Unit Join: num. Unit num has joined the stack.
Technologies
Table 62: General 200 Series Error Messages
Component Message Cause
200 Series Invalid USP unit = x, slot = x, port = x A port was not able to be translated correctly
during the receive.
200 Series In hapiBroadSystemMacAddress call to
'bcm_l2_addr_add' - FAILED : x
Failed to add an L2 address to the MAC table.
This should only happen when a hash collision
occurs or the table is full.
200 Series Failed installing mirror action - rest of the
policy applied successfully
A previously configured probe port is not
being used in the policy. The release notes
state that only a single probe port can be
configured.
200 Series Policy x does not contain rule x The rule was not added to the policy due to a
discrepancy in the rule count for this specific
policy. Additionally, the message can be
displayed when an old rule is being modified,
but the old rule is not in the policy.
200 Series ERROR: policy x, tmpPolicy x, size x, data x x
x x x x x x
An issue installing the policy due to a possible
duplicate hash.
200 Series ACL x not found in internal table Attempting to delete a non-existent ACL.
200 Series ACL internal table overflow Attempting to add an ACL to a full table.
200 Series In hapiBroadQosCosQueueConfig, Failed to
configure minimum bandwidth. Available
bandwidth x
Attempting to configure the bandwidth
beyond it’s capabilities.
200 Series USL: failed to put sync response on queue A response to a sync request was not
enqueued. This could indicate that a previous
sync request was received after it was timed
out.
200 Series USL: failed to sync ipmc table on unit = x Either the transport failed or the message was
dropped.
200 Series usl_task_ipmc_msg_send(): failed to send
with x
Either the transport failed or the message was
dropped.
200 Series USL: No available entries in the STG table The Spanning Tree Group table is full in USL.
200 Series USL: failed to sync stg table on unit = x Could not synchronize unit x due to a
transport failure or API issue on remote unit. A
synchronization retry will be issued.
200 Series Log Messages
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 683