Reference Guide

specified access mode applies. The default is readwrite for the “admin” user and readonly for all other
users.
Note
You must enter the username in the same case you used when you added the user. To see the
case of the username, enter the show users command.
Defaults
•
admin - readwrite
•
other - readonly
Format username snmpv3 accessmode username {readonly | readwrite}
Mode Global Config
no username snmpv3 accessmode
This command sets the SNMPv3 access privileges for the specified user as readwrite for the “admin”
user and readonly for all other users. The username value is the user name for which the specified
access mode will apply.
Format no username snmpv3 accessmode username
Mode Global Config
username snmpv3 authentication
This command specifies the authentication protocol to be used for the specified user. The valid
authentication protocols are none, md5 or sha. If you specify md5 or sha, the login password is also
used as the SNMPv3 authentication password and therefore must be at least eight characters in length.
The username is the user name associated with the authentication protocol.
Note
You must enter the username in the same case you used when you added the user. To see the
case of the username, enter the show users command.
Default no authentication
Format username snmpv3 authentication username {none | md5 | sha}
Mode Global Config
no username snmpv3 authentication
This command sets the authentication protocol to be used for the specified user to none. The username
is the user name for which the specified authentication protocol is used.
Format
no username snmpv3 authentication username
Mode Global Config
Management Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 73