Installation guide
Table Of Contents
- Table of Contents
- Introduction
- Hardware Installation
- Defining a Basic Configuration
- Specifications
- Regulatory Information
- Regulatory Overview
- Wireless Device Country Approvals
- Health and Safety Recommendations
- RF Exposure Guidelines
- International
- EU
- US and Canada
- Power Supply
- Radio Frequency Interference Requirements – FCC
- Radio Frequency Interference Requirements – Canada
- CE Marking and European Economic Area (EEA)
- Statement of Compliance
- Waste Electrical and Electronic Equipment (WEEE)
- Japan (VCCI) - Voluntary Control Council for Interference Class B ITE
- Korea Warning Statement for Class B ITE
- Other Countries
- Customer Support
Using the Initial Setup Wizard
Altitude™ 4521 Series Access Point Installation Guide
45
There's no user intervention or additional settings required within this screen. Its an
additional means of validating the configuration before its deployed. However, if a
screen displays settings not intended as part of the initial configuration, the screen can
be selected from within the Navigation Panel and its settings modified accordingly.
31 If the configuration displays as intended, select the Save/Commit button to implement
these settings to the Access Point’s configuration. If additional changes are warranted
based on the summary, either select the target page from the Navigational Panel, or use
the Back and Next buttons to scroll to the target screen.