Installation Guide
Table Of Contents
- Enterasys Networks, Inc. Firmware License Agreement
- Contents
- About This Guide
- Introduction
- Installation
- Specifications
- Regulatory Information
Installation Separately Ordered Components
2-2
3. Performavisualinspectionofthe WS‐AP3865eforanysignsofphysicaldamage.Contact
ExtremeNetworksifthereareanysignsofdamage.
Separately Ordered Components
ThefollowinglistofaccessoriesareavailablefortheIdentiFiWirelessAccessPointWS‐AP3865e.
Fororderinginformation,contactyourExtremeNetworkssalesrepresentative.
• Antennas.Referto“WS‐AP3865eApprovedExternalAntennas”onpage B‐11andtheIdentiFi
WirelessAPExternalAntennaSitePreparationandInstallationGuideformoreinformation
about
theseantennas.Thisdocumentisavailableat:https://extranet.enterasys.com/downloads/.
•PoweroverEthernet(PoE)Injector.Thefollowing802.3atPoEinjectorsarerecommendedfor
usewiththeWS‐AP3865e:
–PD‐9001GR‐ENT(30W,indoorPoEinjector)
–PD‐9001GO‐ENT(30W,outdoorPoEinjector)
–PD‐9501GR/AC(60W,outdoorPoEinjector)
•Terminatorcap.Thispartislisted
asaspareitemastheWS‐AP3865eisshippedwithsix
terminatorcaps.IfyouarenotattachingsixantennastotheWS‐AP3865e,youmustusea
terminatorcapontheantennaconnectornotbeingused.
–WS‐CAB‐NTERM—Terminator,StandardPolarity,Type‐NPlug,50OHM,1W
• Cables
toconnectthelightningprotectorsontheenclosuretotheantennas.Allcableslisted
belowhaveStandardPolarityType‐Njackandplugconnectors.
–WS‐CAB‐L200C20N—20footLMR200cable
–WS‐CAB‐L400C06N—6footLMR400cable
–WS‐CAB‐L400C20N—20footLMR400cable
–WS‐CAB‐L400C50N—50footLMR400cable
–WS‐CAB‐L400C75N—75foot
LMR400cable
–WS‐CAB‐L600C25N—25footLMR600cable
–WS‐CAB‐L600C50N—50footLMR600cable
WS-AP3865e Installation Procedures
InstalltheWS‐AP3865ebyfollowingtheseprocedures:
• RemovingtheAPCover
1 WS-AP3865e Quick Reference
Table 2-1 WS-AP3865e Supplied Components (Continued)
Quantity Item
Note: When the AP3865 is powered by the Power Injector, the DATA port of the Injector should be
connected to a non PoE switch or, if the switch is PoE capable, PoE must be DISABLED on the
DATA port.
Electrical Hazard: This product should be installed and serviced by a qualified licensed technician,
electrician, or electrical maintenance person familiar with its operation and the hazards involved.