Installation Guide

3 #37201, Main bracket with #37210, Flat Metal-Easy Attach Adaptor.
4 Philps pan-head screws directly onto the wall (not recommended).
Note
The recommended method of installation is using the Main Bracket.
Pre-installation checklist:
•
The mounting surface, item, and hardware must be able to support the AP in all environmental
conditions.
•
The mounting surface should be flat.
Mounting the AP to a wall using the Main Mounting bracket
The main mounting bracket (#37201) ships with the AP and can be used to mount the AP onto a wall.
This is the recommended method of installation for a wall mounting procedure.
1 Remove the mounting bracket attached to the back of the AP.
2 Use the mounting bracket as a template and mark the hole centers on the wall.
Note
The four feet of the bracket must be horizontal and pointing to the right. The flat part of
the large surface must be touching the wall.
3 Drill two holes 83mm (3.270”) apart from each other on the wall where you want to mount the AP.
4 Insert the screws through the bracket and into the holes. Use the screw-in anchors if needed.
5 Insert the Ethernet cable’s RJ45 connector into the LAN1/GE1 port.
6 Slide the AP onto the bracket’s four feet. Ensure that the AP is secured in place and tightened.
Mounting the AP to a wall using the WS-MBI-WALL04 bracket
Mounting the AP to a flat ceiling requires the WS-MBIWALL04 (#30516) bracket, two Philips Pan-head
screws, and two screw-in anchors. They must be purchases separately.
Installation Process
ExtremeWireless™ AP3915e FCC/ROW Install Guide 19