Installation Guide
Table Of Contents
- Table of Contents
- Preface
- 1: Product Overview
- 2: Install the Access Point
- AP410i/e Box Contents
- Access Point Installation Options and Accessories Information
- Install the Access Point on a Drywall or Wood Wall or to a Solid Flat Ceiling
- Install the Access Point on a Suspended or Drop Ceiling with a Flat T-bar
- Install the Access Point on a Junction Box or Gang Box
- Install the Access Point on a Beam
- 3: Antenna Configuration for External Antenna Model Access Point
- 4: Access Points Specifications
- 5: Regulatory Information
- Safety Guidelines
- MPE Statement for Mobile Devices
- Federal Communications Commission (FCC) Notice
- Industry Canada Notice
- Detachable Antenna Usage
- Australia Notice
- Brazil Anatel Statement
- Hazardous Substances
- Supplement to Product Instructions
- NCC Statement
- CE Information
- European Waste Electrical and Electronic Equipment (WEEE) Notice
- Declaration of Conformity in Languages of the European Community
- Index
Install the Access Point on a Flat T-bar Using Main Mounting Bracket and
KT-135628-01 Adapter
Ensure that the T-bar meets the following conditions before installing the main mounting bracket with
the KT-135628-01 adapter on a T-bar:
•
T-bar width can be either 9/16 in. (15 mm) or 15/16 in. (24 mm).
•
T-bar bottom must be flat all the way across.
•
T-bar must be structurally sound.
•
T-bar maximum base thickness must not exceed 0.055 in. (1.4 mm).
Due to manufacturing variation, some adapters can accommodate up to 0.060 in. (1.5 mm)
•
Ceiling tile may protrude up to 0.35 in. (8.89 mm) below the T-bar
If the ceiling tile is not flat and has a protrusion, use the main mounting bracket with the KT-135628-01
adapter. Attach the adapter to the main mounting bracket before attaching the bracket to a T-bar.
1 Attach the T-bar adapter to the main mounting bracket by lining up the small bends on the adapter
with the long raised parts on the main bracket.
2 Pull up the KT-135628-01 adapter locking pin, and twist.
Ensure that the locking pin goes into the locking pin hole on the main bracket and locks in place.
Figure 5: Attach the KT-135628-01 adapter on the main mounting bracket
Install the Access Point
ExtremeMobility™ Access Points AP410i/e 19