Installation Guide
Table Of Contents
- Table of Contents
- Preface
- 1: Product Overview
- 2: Install the Access Point
- AP410i/e Box Contents
- Access Point Installation Options and Accessories Information
- Install the Access Point on a Drywall or Wood Wall or to a Solid Flat Ceiling
- Install the Access Point on a Suspended or Drop Ceiling with a Flat T-bar
- Install the Access Point on a Junction Box or Gang Box
- Install the Access Point on a Beam
- 3: Antenna Configuration for External Antenna Model Access Point
- 4: Access Points Specifications
- 5: Regulatory Information
- Safety Guidelines
- MPE Statement for Mobile Devices
- Federal Communications Commission (FCC) Notice
- Industry Canada Notice
- Detachable Antenna Usage
- Australia Notice
- Brazil Anatel Statement
- Hazardous Substances
- Supplement to Product Instructions
- NCC Statement
- CE Information
- European Waste Electrical and Electronic Equipment (WEEE) Notice
- Declaration of Conformity in Languages of the European Community
- Index
Callout Description
A KT-135628-01 adapter
B KT-135628-01 T-bar holder
C KT-135628-01 adapter locking pin
3 Slide the KT-135628-01 T-bar holder onto the T-bar and replace the tiles to hold the adapter onto the
T-bar.
4 Hold and rock the access point back and forth to ensure that it is securely mounted.
5 Attach the RJ45 connector to the GE1 port.
Install the Access Point on a Flat T-bar Using the DCFLUSH bracket
Ensure that the T-bar meets the following conditions before installing the DCFLUSH bracket on it:
•
T-bar width must be 9/1 in. (15mm), 15/16 in. (24mm), or 1.5 in. (38 mm).
•
T-bar bottom must be flat all the way across.
•
T-bar must be structurally sound.
•
T-bar maximum base thickness must not exceed 0.080 in. (2 mm).
•
Ceiling tile must be flat all the way across.
•
Maximum ceiling tile protrusion allowed is 0.015 in. (0.380 mm).
The WS-MBI-DCFLUSH (#37211) bracket is used on a flat T-bar when you do not want to use the main
mounting bracket on it.
1 Remove the ceiling panels around the T-bar.
2 Open the movable sliding part of the DCFLUSH bracket to give the stationary and slider T-bar more
space.
Figure 6: DCFLUSH bracket parts and T-bar
Install the Access Point
ExtremeMobility™ Access Points AP410i/e 20