Installation Guide
Table Of Contents
- Table of Contents
- Preface
- 1: Product Overview
- 2: Install the Access Point
- AP410i/e Box Contents
- Access Point Installation Options and Accessories Information
- Install the Access Point on a Drywall or Wood Wall or to a Solid Flat Ceiling
- Install the Access Point on a Suspended or Drop Ceiling with a Flat T-bar
- Install the Access Point on a Junction Box or Gang Box
- Install the Access Point on a Beam
- 3: Antenna Configuration for External Antenna Model Access Point
- 4: Access Points Specifications
- 5: Regulatory Information
- Safety Guidelines
- MPE Statement for Mobile Devices
- Federal Communications Commission (FCC) Notice
- Industry Canada Notice
- Detachable Antenna Usage
- Australia Notice
- Brazil Anatel Statement
- Hazardous Substances
- Supplement to Product Instructions
- NCC Statement
- CE Information
- European Waste Electrical and Electronic Equipment (WEEE) Notice
- Declaration of Conformity in Languages of the European Community
- Index
2 Remove the LAN cable from the coverplate.
3 Place the WALL04 bracket, with the locking tab pointing up, against the mounting holes on the box.
Note
The bracket must be square to the rest of the room walls, and the two holes that are being
used must be on the opposite side of large center hole on the WALL04 bracket.
If the WALL04 bracket holes do not align with the mounting holes on the junction or gang box, cut
and enlarge the holes on the WALL04 bracket.
4 Attach the WALL04 bracket to the junction or gang box using the screws removed from the junction
or gang box.
Caution
Over tightening the screws will cause the WALL04 bracket to bend. If the bracket bends,
you will not be able to align and slide the access point onto the keyhole posts.
5 Connect the GE1 cable to the access point.
6 Slide the access point on the keyhole slots of the WALL04 bracket until you hear it lock in place.
Install the Access Point on a Beam
Verify that the:
•
Beam attachment area is at least 0.5 in. (12.7 mm) wide and as long as the access point's largest
dimension.
•
Beam mounting surface is less than 0.650 in. (16.5 mm) thick.
If you do not want to install your access point on a solid flat surface, you can attach it to a beam using
the beam clip accessory (BRKT-000147A-01). The access point must be attached to a beam only if the
beam is flat, and can support the access point in all environmental conditions.
Figure 8: Beam clip accessory
Install the Access Point
ExtremeMobility™ Access Points AP410i/e 23