Installation Guide
Table Of Contents
- Table of Contents
- Preface
- 1: Product Overview
- 2: Install the Access Point
- AP410i/e Box Contents
- Access Point Installation Options and Accessories Information
- Install the Access Point on a Drywall or Wood Wall or to a Solid Flat Ceiling
- Install the Access Point on a Suspended or Drop Ceiling with a Flat T-bar
- Install the Access Point on a Junction Box or Gang Box
- Install the Access Point on a Beam
- 3: Antenna Configuration for External Antenna Model Access Point
- 4: Access Points Specifications
- 5: Regulatory Information
- Safety Guidelines
- MPE Statement for Mobile Devices
- Federal Communications Commission (FCC) Notice
- Industry Canada Notice
- Detachable Antenna Usage
- Australia Notice
- Brazil Anatel Statement
- Hazardous Substances
- Supplement to Product Instructions
- NCC Statement
- CE Information
- European Waste Electrical and Electronic Equipment (WEEE) Notice
- Declaration of Conformity in Languages of the European Community
- Index
5 Regulatory Information
Safety Guidelines
MPE Statement for Mobile Devices
Federal Communications Commission (FCC) Notice
Industry Canada Notice
Detachable Antenna Usage
Australia Notice
Brazil Anatel Statement
Hazardous Substances
Supplement to Product Instructions
NCC Statement
CE Information
European Waste Electrical and Electronic Equipment (WEEE) Notice
Declaration of Conformity in Languages of the European Community
Safety Guidelines
The following safety guidelines are intended to protect your personal safety and prevent damage to the
equipment.
Attention
Only qualified personnel should perform installation procedures. Within the context of the
safety notes in this documentation, qualified persons are defined as persons who are
authorized to commission, ground and label devices, systems, and circuits in accordance with
established safety practices and standards. A qualified person understands the requirements
and risks involved with installing outdoor electrical equipment in accordance with national
codes.
MPE Statement for Mobile Devices
This equipment complies with EU radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 26 cm between the
radiator and your body.
Federal Communications Commission (FCC) Notice
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
ExtremeMobility™ Access Points AP410i/e 29