Installation Guide
Table Of Contents
- Table of Contents
- Preface
- 1: Product Overview
- 2: Install the Access Point
- AP410i/e Box Contents
- Access Point Installation Options and Accessories Information
- Install the Access Point on a Drywall or Wood Wall or to a Solid Flat Ceiling
- Install the Access Point on a Suspended or Drop Ceiling with a Flat T-bar
- Install the Access Point on a Junction Box or Gang Box
- Install the Access Point on a Beam
- 3: Antenna Configuration for External Antenna Model Access Point
- 4: Access Points Specifications
- 5: Regulatory Information
- Safety Guidelines
- MPE Statement for Mobile Devices
- Federal Communications Commission (FCC) Notice
- Industry Canada Notice
- Detachable Antenna Usage
- Australia Notice
- Brazil Anatel Statement
- Hazardous Substances
- Supplement to Product Instructions
- NCC Statement
- CE Information
- European Waste Electrical and Electronic Equipment (WEEE) Notice
- Declaration of Conformity in Languages of the European Community
- Index
1 Product Overview
AP410i/e Features
AP410i/e Power Source
LED Indicators
The AP410i/e access points are indoor model 802.11ax access points. The “i” in AP410i indicates that the
access point comes with internal antennas and the “e” indicates that it comes with external antenna
connectors. The access points feature built-in dual-band radios, two band-locked radios, eight WiFi
internal or external antennas, and one Bluetooth Low Energy (BLE) antenna.
The AP410i/e is mounted on a flat surface such as a wall, a solid flat ceiling, and to a junction or gang
box, and can be installed on a suspended or drop ceiling.
Note
The AP410i/e requires a minimum base firmware of WiNG 7.3.0.
In this document, the access points are addressed as AP410i/e when the product features and
installation procedures are the same for both access points.
AP410i/e Features
The AP410i/e access points have the following features:
•
Radios: Three 802.11ax radios
•
One 2X2 2.4 GHz radio
•
One 4X4 5 GHz radio
•
One 2X2 2.4 GHz and 5 GHz radio
•
One 2.4 GHz IoT radio
•
Console port: RJ45
•
Two Ethernet ports:
•
1 x 10/100/1000 Mbps auto-negotiation Ethernet port, RJ45
•
One multi-rate GE/2.5 GE Ethernet port
•
LEDs: Seven – all LEDs will be powered on during reset and will connect to general purpose input/
output (GPIO) pins
•
One reset button
•
One Kensington lock
•
One safety hanger provision
•
One USB 2.0 type A connector
•
Power: PoE 802.3at and 802.3bt (see AP410i/e Power Source for details)
•
Antennas:
ExtremeMobility™ Access Points AP410i/e 8