AP410C Hardware Guide 1 AP410C Hardware User Guide Read about and view specifications and compliance information for the AP410C in this topic. Install the AP410C using this topic. The AP410C is a high-performance 802.11ax dual-5G. dual band access point designed for indoor high-density environments. This device supports IEEE 802.11ax Orthogonal Frequency-Division Multiple Access (OFDMA) multi-user access. For regulatory and compliance information, see "Regulatory Compliance Statements".
AP410C Hardware Guide 2 This icon indicates a general caution. Failure to comply with a caution notification can result in damage to equipment. This icon indicates an electrical caution. Failure to comply with an electrical notification can result in serious injury or death, and extensive damage to equipment. This icon indicates a laser caution. Failure to comply with a laser caution can result in serious injury.
AP410C Hardware Guide 4 Once the bracket is secure, install the AP using the following steps: 1. Align the red dot on the bottom of the AP with the red dot on the bracket. 2. Lift the AP straight up and keep the red dots aligned until the bracket is seated in the round depression on the bottom of the device. 3. Rotate the AP clockwise until it clicks into place on the bracket.
AP410C Hardware Guide 5 Mounting brackets are available for these devices that will allow you to install them on non-standard ceiling tracks. The following accessory brackets are available: l AH-ACC-BKT-AX-IL: Mounting bracket for Interlude ceilings. l AH-ACC-BKT-AX-SL: Mounting bracket for Silhouette 1/8" and Silhouette 1/4" ceilings. l AH-ACC-BKT-AX-TB: Mounting bracket for Prelude 15/16" and Suprafine 9/16" ceilings. l AH-ACC-BKT-AX-WL: Mounting bracket for direct-to-wall installations.
AP410C Hardware Guide 6 Mount the AP on a Wall Use the holes in the bracket as a template to mark the wall. Drill holes in the wall and attach the bracket to the wall using wall screws and wall anchors if necessary. Attach the AP to the bracket in the same manner as shown in the previous section. Lock the AP You can secure the AP using a Kensington ® lock in the lock slot on the device, or you can use a security bracket and a crosshead screw or a security screw.
AP410C Hardware Guide 7 the button. To reboot the device, press the button for 5 seconds. To return the configuration to the factory default settings, press it for at least 10 seconds. After releasing the button, the indicator light goes dark, and then glows steady amber while the firmware loads and the system performs a self-test. After the software finishes loading and the AP has connected to ExtremeCloud IQ, the status indicator glows steady white.
AP410C Hardware Guide 8 802.11ac l 802.11ac modulation (256-QAM) l 2.4 - 2.48 GHz MCS0-9, NSS=1-2 l 5150-5250, 5725-5850 MHz operating frequency l Rates: MCS0 - MCS9, NSS =1-2 l l 2x2 MIMO radio VHT20/VHT40/VHT80 support (VT40 and VT80 for 5 GHz only) 802.11ax l 5150-5250, 5725-5850 MHz operating frequency l 2.4 - 2.48 GHz operation frequency l 802.
AP410C Hardware Guide 9 Power: 2.4 GHz: Tolerance +2/-2 dB @25°C Channel Data Rate Power (dBm) 11b 1,2,5.5,11 18 11g 54 Mbps 15 48 Mbps 16 36 Mbps 17 6 Mbps 18 MCS 0,1,2 18 MCS 3 17 MCS 4, 5 16 MCS 6,7 15 MCS 8,9 14 MCS 10,11 12 1 Mbps -99 11 Mbps -90 6 Mpbs -96 36 Mpbs -84 48 Mbps -80 54 Mbps -78 MCS 0 -95 MCS 1 -91 MCS 2 -89 MCS 3 -86 MCS 4 -83 MCS 5 -79 MCS 6 -77 MCS 7 -76 MCS 8 -72 MCS 9 -70 MCS 10 -67 MCS 11 -64 HE20 2.
AP410C Hardware Guide 10 AP410C Power: 5 GHz: Mode Data Rate Power (dBm) 11a 54 Mbps 17 48 Mbps 17 36 Mbps 18 6 Mbps 19 MCS 0, 1, 2 19 MCS 3, 4 17 MCS 5, 6 16 MCS 7, 8 15 MCS 9 14 MCS 10 13 MCS 11 12 MCS 0, 1, 2 17 MCS 3, 4, 5 16 MCS 7, 15, 23 14 MCS 6, 7, 8 15 MCS 10 13 MCS 11 12 MCS 0,1,2 17 MCS 3,4,5 16 MCS 6,7,8 15 MCS 9 14 MCS 10 13 MCS 11 12 6 Mbps -94 36 Mbps -83 48 Mbps -79 54 Mbps -77 MCS 0 -94 MCS 1 -91 MCS 2 -88 MCS 3 -86 MCS 4
AP410C Hardware Guide Mode 11n HE40 HE80 AP410C Hardware Guide 11 Data Rate Power (dBm) MCS 10 -66 MCS 11 -63 MCS 0 -92 MCS 1 -88 MCS 2 -86 MCS 3 -83 MCS 4 -80 MCS 5 -76 MCS 6 -74 MCS 7 -73 MCS 8 -69 MCS 9 -67 MCS 10 -63 MCS 11 -60 MCS 0 -88 MCS 1 -85 MCS 2 -83 MCS 3 -80 MCS 4 -77 MCS 5 -73 MCS 6 -71 MCS 7 -69 MCS 8 -66 MCS 9 -64 MCS 10 -60 MCS 11 -57 11
AP410C Hardware Guide 12 Tolerance +2/-2 dB @25° C Mode Data Rate Power (dBm) 11a 6 Mbps 19 36 Mbps 18 48 Mbps 16 54 Mbps 15 MCS 0,1, 2, 3, 4, 8, 9, 10, 11 19 MCS 13, 21 18 MCS 14, 22 16 MCS 15, 23 15 MCS 12, 16, 17, 18, 19, 20 19 MCS 0,1,2, 3, 4, 8 19 MCS 5, 13, 21 18 MCS 7, 15, 23 14 MCS 9, 10, 11, 12, 16 19 MCS 10 13 MCS 17, 18, 19, 20 19 MCS 0,1,2 17 MCS 3,4,5 16 MCS 6,7,8 15 MCS 9 14 MCS 10 13 MCS 11 12 6 Mbps -94 36 Mbps -83 48 Mbps -79 54 Mbps -
AP410C Hardware Guide 13 Mode Data Rate Power (dBm) 11n HE40 MCS 0 -92 MCS 1 -88 MCS 2 -86 MCS 3 -83 MCS 4 -80 MCS 5 -76 MCS 6 -74 MCS 7 -73 MCS 8 -69 MCS 9 -67 MCS 10 -63 MCS 11 -60 MCS 0 -88 MCS 1 -85 MCS 2 -83 MCS 3 -80 MCS 4 -77 MCS 5 -73 MCS 6 -71 MCS 7 -69 MCS 8 -66 MCS 9 -64 MCS 10 -60 MCS 11 -57 HE80 Device Specifications l Chassis dimensions: Per hardware spec: 8.07” x 8.07” x 1.46” (205 mm x 205 mm x 37 mm l Weight: 2.61 lbs (1.
AP410C Hardware Guide 14 AP410C AP410C Hardware Guide 14
AP410C Hardware Guide 15 AP410C Hardware Guide 15
AP410C Hardware Guide 16 AP410C Hardware Guide 16
AP410C Hardware Guide 17 AP410C Hardware Guide 17
AP410C Hardware Guide 18 AP410C Hardware Guide 18
AP410C Hardware Guide 19 AP410C Hardware Guide 19
AP410C Hardware Guide 20 Power and Environmental Specifications Power Specifications l PoE input voltage range: 37-57 V l ESD Protection: 8 kV contact discharge / 15 kV air discharge Power Consumption l PoE: 26.7W with USB, 5V/1A, 21.7W without USB l 802.3at at Ethernet switch l Surge Protection: 1.
AP410C Hardware Guide 21 Regulatory Compliance Statements The regulatory compliance statements in this section apply to Extreme Networks devices. Japan Indoor Use For Japan, the AP410C is restricted for indoor use in the 5150-5350 MHz band only. Japan Equipment VCCI-B Statement Compliance Statement - Europe EU Declaration of Conformity View full CE Declaration of Compliance and this information online at www.aerohive.com/support/regulatory-compliance Extreme Networks, Inc.
AP410C Hardware Guide l l l 22 Slovenian [Slovenija]: [Extreme Networks] potrjuje, da je tip radijske opreme [AP410C] skladen z Direktivo 2014/53/EU. Spanish [Español]: Por la presente, [Extreme Networks] declara que el tipo de equipo radioeléctrico [AP410C] es conforme con la Directiva 2014/53/UE. Swedish [Sverige]: Härmed försäkrar [Extreme Networks] att denna typ av radioutrustning [AP410C] överensstämmer med direktiv 2014/53/EU. USA and Canada Radio Frequency Bands a. USA l 802.11b/g/n/ac: 2.
AP410C Hardware Guide l 23 BLE: 2402-2480 MHz EIRP<8 dBm Finnish [Suomi]: Tämä tuote tukee seuraavia radiotaajuuksia ja tehoja EU-versiossa: l 802.11a/b/g/n, 2.4 GHz band: 2412-2472 MHz EIRP<20 dBm l 802.11 a/ac/n/ax: 5 GHz band: 5150-5350 MHz EIRP<23 dBm, 5470-5725 MHz EIRP<30 dBm, 5730-5850 MHz<14 dBm l BLE: 2402-2480 MHz EIRP<8 dBm French [Français]: Ce produit prend en charge les fréquences radio et les niveaux de puissance suivants dans la version EU: l 802.11b/g/n/ac, 2.
AP410C Hardware Guide l 802.11b/g/n/ac, 2.4 GHz band: 2400-2483 MHz EIRP<20 dBm l 802.11a/ac/n/ax: 5 GHz band: 5150-5350 MHz EIRP<23 dBm, 5470-5725 MHz EIRP<30 dBm, 5730-5850 MHz<14 dBm l BLE: 2402-2480 MHz EIRP<8 dBm 24 Slovak [Slovensky]:Tento produkt podporuje nasledujúce rádiové frekvencie a úrovne napájania vo verzii EÚ: l 802.11b/g/n/ac, 2.4 GHz band: 2400-2483 MHz EIRP<20 dBm l 802.
AP410C Hardware Guide 25 Finnish [Suomi]: Säteilytysvaatimusten täyttämiseksi nämä laitteet on asennettava vähintään 8" (20 cm) etäisyydelle ihmisistä tai eläimistä. Rajoitukset: 5150-5350 MHz vain sisäkäyttöön. French [Français]: Pour répondre aux exigences d'exposition aux rayonnements, ces appareils devraient être installés à une distance minimale de 8" (20 cm) des personnes ou des animaux. Restrictions: 5150-5350 MHz pour usage intérieur seulement.
AP410C Hardware Guide 26 FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
AP410C Hardware Guide 27 在 5.25-5.35 秭 赫 頻 帶 內操 作 之 無 線 資 訊 傳 輸 設 備 ,限 於 室 內使 用 。 無 線 資 訊 傳 設 備 的 製 造 廠 商 應 確 保 頻 穩 定 性 ,如 依 製 造 廠 商 使 用 手 冊 上 所 述 正 常 操 作 ,發 射 的 信 號 應 維 持 於 操 作 頻 帶 中 。 Taiwan MPE Warning 電 磁 波 曝 露 量 MPE標 準 值 (MPE) 1mW/cm2,送 測 產品 實 值 為 0.734 mW/cm2 European Waste Electrical and Electronic Equipment (WEEE) Notice In accordance with Directive 2012/19/EU of the European Parliament on waste electrical and electronic equipment (WEEE): 1.