Release Notes

Extreme Campus Controller Customer Release Notes
8/6/2021 P/N: 9036846-05 Subject to Change Without Notice Page: 3 of 21
F0615-O
Supported for Wi-Fi 6 AP (AP300/AP400/AP500 series) models. Requires client
compatibility with feature.
Formalized support for Wireless Mesh for Wi-Fi 6 AP models (AP300, AP400,
AP500 i/e/h).
Access points can belong to one mesh point at a time, and only one radio of the
AP can be used for mesh point (backhaul) connection.
Root APs must be statically configured to the same manually assigned non-DFS
channel. Non-root (node) APs on the same band will automatically scan for Root
APs on the same mesh point.
Mesh points managed by Extreme Campus Controller (Campus mode) cannot
extend mesh points for AP39xx or ExtremeWireless WiNG installs.
XCC-543
Added indication of VxLAN tunnel state between AP and switches.
In a High Availability Pair, only one Extreme Campus Controller offers a tunnel state
report. Synchronizing the tunnel state to the second Extreme Campus Controller in a
High Availability Pair will be supported in a future release.
XCC-240
Added protection from importing configurations that contain distributed or proxied
sites.
XCC-218
Added the ability to dynamically assign a topology to a user without modifying the
set of filter rules assigned to a particular end system.
XCC-23
Added redundancy for internal DHCP server high availability setup. XCC-21
Enhanced configuration model to support the definition of Hotspot 2.0 service for
AP39xx and Wi-Fi 6 access point models (Campus mode).
XCC-5
Corrected configuration issue where Off Channel Scanning (OCS) was not enabled
when 802.11k was selected.
XCC-535
Changes in 05.16.03.0015 I.D
Improved validation of External Captive Portal URL and prevented saving of incorrect
configuration entry.
XCC-638