Installation Guide

Configuring the ExtremeControl Engine
42 of 65
Configuration of the appliance network settings is now complete. Enter 0
or any key other than a valid selection to continue. If you need to make a
change, enter the appropriate number from the choices listed below.
==============================================================
==
0. Accept the current settings
1. Edit NAC Appliance settings
2. Edit SNMP settings
3. Edit date and time
4. Modify all settings
==============================================================
===
Enter selection [0]:
When you see the following screen, configuration is complete.
==============================================================
===
Extreme Networks - ExtremeControl Appliance - Setup Complete
==============================================================
===
Setup of the NAC Appliance is now complete. Details of the appliance
setup process are located in the log files in the /var/log/install directory.
==============================================================
===
Note: After you have completed the configuration, it is important to take a
snapshot of your engine configuration to be used in the event an engine
image reinstall is required. For instructions on how to take a snapshot, see
your vSphere client documentation.
You are now ready to use Extreme Management Center to manage your
ExtremeControl. If this is your initial commissioning of the engine, you can
launch Extreme Management Center and select Getting Started from the Help
menu for information on using Extreme Management Center to configure and
manage your ExtremeControl.
If you have reinstalled your ExtremeControl software, use Extreme Management
Center to enforce the engine. Enforcing writes your Extreme Management
Center configuration information to the engine.