Installation Guide

Configuring the ExtremeAnalytics Engine
51 of 65
3. Interface Tunnel Mirrored
Separate interfaces are configured for management and
monitoring traffic.
The monitoring interface will get its own IP Address
and GRE Tunnels will be configured for traffic monitoring.
Suitable for feeds from Coreflow switches.
4. Manual Mode
The interface and tunneling configurations will not
be modified by this script, leaving them to be manually
edited by the user instead.
Please select a deployment mode [2]:
Note: If you select deployment mode 4, refer to the ExtremeAnalytics
Deployment Guide for information on how to configure your
deployment manually.
5. If you selected deployment mode 1, 2, or 3, the Appliance (Engine) Network
Configuration for eth0 screen appears. For each line, enter the requested
configuration information and press [Enter].
If you will be using DNS, the IP address of the name server should be
provided. If you are using a name server then you must enter a domain
name for the engine. The NIS server is used to authenticate users
logging into the engine. If you are using an NIS server, make sure the
NIS domain name is valid or users may not be able to log in to the
Extreme Management Center applications.
==========================================================
ExtremeAnalytics Appliance Network Configuration for eth0
==========================================================
Enter information below to configure eth0
Enter the hostname for the appliance (Required):
Enter the IP address for eth0 on 10.54.56.141
[10.54.56.141]:
Enter the IP netmask [255.255.255.0]:
Enter the gateway address [10.54.56.2]:
Enter the IP address of the name server (Optional):
Enter the domain name for 10.54.56.141 (Optional):