Installation Guide

Configuring the ExtremeAnalytics Engine
53 of 65
9. Specify one or more GRE tunnel interfaces. For each line, enter the requested
configuration information and press [Enter].
==========================================================
ExtremeAnalytics Appliance Network Configuration for
Tunnel Interfaces
==========================================================
Enter the interface name for Tunnel Configuration [eth1]:
eth4
Enter information below to configure eth4
Enter the IP address for eth4 on pv88 [10.54.211.116]:
Enter the IP netmask [255.255.255.0]:
Enter the gateway address [10.54.211.1]:
Would you like to add another interface for Tunnel
Configuration (y/n) [n]? y
Enter the interface name for Tunnel Configuration [eth1]:
eth5
Enter information below to configure eth5
Enter the IP address for eth5 on pv88 [10.54.222.117]:
Enter the IP netmask [255.255.255.0]:
Enter the gateway address [10.54.222.1]:
Would you like to add another interface for Tunnel
Configuration (y/n) [n]? n
10. Enter the IP addresses for one or more GRE tunnels. For each line, enter the
requested configuration information and press
[Enter]
==========================================================
ExtremeAnalytics Appliance GRE Configuration
==========================================================
Remote mirroring can be configured in Coreflow Switches
using GRE tunnels.
This requires a specific mirroring configuration enabled
on the switches.
Enter the SRC IP address for the GRE Tunnel
[10.54.211.116]:
Enter the DST IP address for the GRE Tunnel [192.168.1.1]:
10.54.1.116
Add another GRE Tunnel (y/n) [n]? y