Specifications

400 ExtremeWare XOS 10.1 Command Reference Guide
STP Commands
show stpd
show stpd {<stpd_name> | detail}
Description
Displays STPD settings on the switch.
Syntax Description
Default
N/A.
Usage Guidelines
The command displays the following STPD information:
• STPD name
• STPD state
• STPD mode of operation
• Autobind mode
• Rapid Root Failover
• Tag
• Ports
• Active VLANs
• Bridge Priority
• Bridge ID
• Designated root
• STPD configuration information
You can create, configure, and enable one or more STP domains and use the show stpd command to
display STP configurations. Use the
create stpd command to create an STP domain. Use the enable
stpd
command to enable an STPD. If you have considerable knowledge and experience with STP, you
can configure the STPD using the
configure stpd commands. However, the default STP parameters
are adequate for most networks.
Example
The following command displays STPD settings on an STPD named Backbone_st:
show stpd backbone_st
The following is sample output from this command:
Stpd: backbone_st Stp: ENABLED Number of Ports: 51
stpd_name Specifies an STPD on the switch.
detail Specifies that STPD settings should be shown for each STPD.