User guide

show service details
ExtremeWarePx1 1.2 Command Reference Guide 281
Domain: 10.6.2.100
Pattern-rule: default
Current connection: 0
Total connections: 0
Peak concurrent: 0
server-group sg2 policy wlc
server of last resort not specified
Pattern-rule: *.gif
Current connection: 50
Total connections: 359
Peak concurrent: 309
server-group sg2 policy wlc
server of last resort not specified
Service 10.6.2.101 port 900 tcp service http layer7
Domain: default
Pattern-rule: default
Current connection: 0
Total connections: 0
Peak concurrent: 0
server-group sg2 policy wlc
server of last resort not specified
This example shows details about a single service.
SummitPx1:47 # sh service vip 10.6.2.100 port 8080 det
Service 10.6.2.100 port 8080 tcp service http layer7
Domain: default
Pattern-rule: default
Current connection: 0
Total connections: 0
Peak concurrent: 0
server-group sg2 policy wlc
server of last resort not specified
flags: E - check Enabled, D - down, U - Up, R - mac is resolved,
N - mac is not resolved, F - forced down
run - '>' than or '<' than 0, number of consecutive passed or failed respectively
ra - restore after, fa - fail after, left - secs till next check
index IP port proto flg curr-conns max-connections run ra fa
10.6.3.205 ICMP URE 2 2 2
20 10.6.3.205 80 HTTP URE 5 10000 2 2 2
10.6.3.206 ICMP URE 2 2 2
21 10.6.3.206 80 HTTP URE 5 10000 2 2 2
10.6.3.207 ICMP URE 2 2 2
22 10.6.3.207 80 HTTP URE 5 10000 2 2 2
10.6.3.208 ICMP URE 2 2 2
23 10.6.3.208 80 HTTP URE 5 10000 2 2 2
10.6.3.209 ICMP URE 2 2 2
24 10.6.3.209 80 HTTP URE 5 10000 2 2 2