User's Manual
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installing the Ethernet Adapter
- Configuring the Ethernet Adapter
- Using Secure Web Server Connection
- Using the Enterasys Networks Wireless Infrastructure Device Manager
- Using the Configuration Management System
- Clearing and Applying System Configuration Settings
- Changing System Properties
- Setting IP Network Properties
- Setting Wireless Network Properties
- Manually Selecting Radio Channels
- Setting Up an Ad-Hoc Network
- Changing Wireless Security Settings
- Changing RADIUS Settings
- Changing SNMP Settings
- Using the Access Control List
- Serial Port
- Resetting the Ethernet Adapter
- Restoring the Ethernet Adapter to Factory Defaults
- Upgrading the System
- Changing the Administration Login Name and Password
- Backing up a Configuration
- Restoring a Configuration
- Logging Out
- Clearing the Ethernet Client List
- Viewing Connection Status
- Viewing System Summary
- Troubleshooting
- Obtaining Support for Your Enterasys Networks Product
- End User License Agreement
- Regulatory Information
12 CHAPTER 2: INSTALLING THE ETHERNET ADAPTER
Figure 3 shows the front view of the Ethernet Adapter, including the LEDs and
connecting ports. It also shows the cradle, which is used to mount the
Ethernet Adapter to a wall or to install the Ethernet Adapter on a flat surface.
Figure 3 Ethernet Adapter
Observing Safety
Precautions
This equipment must be installed in compliance with local and national
building codes, regulatory restrictions, and FCC rules. For the safety of
people and equipment, only professional network personnel should
install the Ethernet Adapter.
WARNING: To comply with FCC radio frequency (RF) exposure limits, a
minimum body-to-antenna distance of 20 cm (8 in.) must be maintained
when the Ethernet Adapter is operational.
WARNING: To avoid possible injury or damage to equipment, you must
use either the provided power supply or power supply equipment that is
safety certified according to UL, CSA, IEC, or other applicable national or
international safety requirements for the country of use. All references to
power supply in this document refer to equipment meeting these
requirements.
WARNUNG: In Übereinstimmung mit den von der FCC (Federal
Communications Commission) festgelegten Grenzwerten für die
Einwirkung von Radiowellen muss bei Betrieb des Ethernet-Adapters der
Abstand zwischen Körper und Antenne 20 cm betragen.
WARNUNG: Zur Vermeidung möglicher Verletzungen oder Schäden am
Gerät muss entweder das mitgelieferte Netzteil oder ein Netzteil
verwendet werden, das von der UL (Underwriters Laboratories Inc.), CSA
Power Port
11a/b/g Wireless
Ethernet Adapter
Serial Port
Ethernet Port