User's Manual
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installing the Ethernet Adapter
- Configuring the Ethernet Adapter
- Using Secure Web Server Connection
- Using the Enterasys Networks Wireless Infrastructure Device Manager
- Using the Configuration Management System
- Clearing and Applying System Configuration Settings
- Changing System Properties
- Setting IP Network Properties
- Setting Wireless Network Properties
- Manually Selecting Radio Channels
- Setting Up an Ad-Hoc Network
- Changing Wireless Security Settings
- Changing RADIUS Settings
- Changing SNMP Settings
- Using the Access Control List
- Serial Port
- Resetting the Ethernet Adapter
- Restoring the Ethernet Adapter to Factory Defaults
- Upgrading the System
- Changing the Administration Login Name and Password
- Backing up a Configuration
- Restoring a Configuration
- Logging Out
- Clearing the Ethernet Client List
- Viewing Connection Status
- Viewing System Summary
- Troubleshooting
- Obtaining Support for Your Enterasys Networks Product
- End User License Agreement
- Regulatory Information
22 CHAPTER 2: INSTALLING THE ETHERNET ADAPTER
Ethernet Adapter Default Settings
Table 4 shows the Ethernet Adapter configuration factory defaults.
Table 4 Factory Default Settings
Property Default Setting
Device Name RoamAbout Ethernet Adapter - RBTSA
Device Location None (blank)
Country For U.S. version, United States and Canada
For non-U.S. version, set by the user
Client Mode Support multiple wired Ethernet clients
IP Network Setting Obtain IP address automatically
IP Address Obtained automatically (with a DHCP server)
169.254.2.2 (without a DHCP server)
Subnet Mask Obtained automatically (with a DHCP server)
255.255.0.0 (without a DHCP server)
Gateway IP Address Obtained automatically (with a DHCP server)
0.0.0.0 (without a DHCP server)
Network Mode Wireless Client (Infrastructure)
Radio Mode Auto Select
Wireless LAN Service Area Attach to any WLAN Service Area (ESSID) automatically
Channel Selection Automatic Best Channel (uses access point setting)
Transmit Power 100%
Antenna Selection Internal
Data Preamble Long (if Network Mode is set to Ad-Hoc)
Same as access point setting (if Network Mode is set
to Wireless Client [Infrastructure])
Security Setting Open System (no security)
802.1x Authentication State Disabled
SNMP Enabled
Access Control List Disabled
Administration Login Name admin
Administration Password None (blank)
TFTP Server IP Address None
FTP Server IP Address None