User's Manual
Table Of Contents
- Contents
- About This Guide
- Introduction
- Installing the Ethernet Adapter
- Configuring the Ethernet Adapter
- Using Secure Web Server Connection
- Using the Enterasys Networks Wireless Infrastructure Device Manager
- Using the Configuration Management System
- Clearing and Applying System Configuration Settings
- Changing System Properties
- Setting IP Network Properties
- Setting Wireless Network Properties
- Manually Selecting Radio Channels
- Setting Up an Ad-Hoc Network
- Changing Wireless Security Settings
- Changing RADIUS Settings
- Changing SNMP Settings
- Using the Access Control List
- Serial Port
- Resetting the Ethernet Adapter
- Restoring the Ethernet Adapter to Factory Defaults
- Upgrading the System
- Changing the Administration Login Name and Password
- Backing up a Configuration
- Restoring a Configuration
- Logging Out
- Clearing the Ethernet Client List
- Viewing Connection Status
- Viewing System Summary
- Troubleshooting
- Obtaining Support for Your Enterasys Networks Product
- End User License Agreement
- Regulatory Information
4
TROUBLESHOOTING
Diagnosing
Problems
If you have difficulty with the Ethernet Adapter, try the solutions in the
following table.
Table 15 Troubleshooting
Symptom Solution(s)
16 devices have been
connected to the Ethernet
Adapter, either simultaneously
or sequentially. After
connecting another device,
the new device cannot
associate with the network.
The Ethernet Adapter supports up to 16 specific clients
(for example, computers and printers) and keeps track
of them using a client list of MAC addresses. After the
client limit is reached, you must clear the client list to
allow a new client to associate. For example, in a hub
configuration with 16 clients connected, if you
disconnect a desktop computer and connect a laptop
in its place, you must clear the client list to establish
network association.
1 Disconnect a client by unplugging its Ethernet cable
from the hub.
2 Use the Enterasys Networks Wireless Infrastructure
Device Manager to select the Ethernet Adapter and
launch its Configuration Management System.
3 Under System Configuration, click Ethernet Client
List. The Ethernet Client List page appears. Click
Clear Client List.
4 Connect the new client by plugging its Ethernet
cable into the hub.