Installation Guide
Table Of Contents
- ExtremeSwitching SLX 9030 Hardware Installation Guide
- Preface
- About this Document
- Device Overview
- Preparing for the Installation
- Mounting the Device
- Mounting options
- Mounting precautions
- Standalone installation
- Installing the device in a rack
- Four-post rack mount kit installation (XBR-R000297)
- Installing the Universal Two-Post Rack Kit (XEN-R000294)
- Installing the Universal Four-Post Rack Kit (XEN-R000296)
- Initial Setup and Verification
- Initial setup and configuration checklist
- Items required
- Providing power to the device
- Establishing a serial connection
- Configuring a static IP address
- Establishing an Ethernet connection
- Customizing the chassis and host names
- Configuring the DNS service
- Verifying correct operation
- Setting the date and time
- Backing up the configuration
- Installing cable management kit
- Transceivers and Cables
- Supported transceivers and cables
- Time and items required
- Precautions specific to transceivers and cables
- Cleaning the fiber-optic connectors
- Managing cables
- Installing an SFP+ transceiver
- Replacing an SFP+ transceiver
- Installing a QSFP28 transceiver
- Replacing a QSFP28 transceiver
- Breakout cables
- Verifying transceiver operation
- Monitoring the Device
- Power Supplies
- Fan Assemblies
- ExtremeSwitching SLX 9030 Technical Specifications
- SLX 9030 Switch Specifications
- Power and Heat Dissipation
- Power Supply Specifications
- Acoustics Specifications
- SLX 9030 Software Specifications
- Ethernet
- LEDs
- Other
- Weight and physical dimensions
- Data port specifications (Ethernet)
- Serial port specifications (pinout RJ-45)
- Serial port specifications (pinout - mini-USB)
- Serial port specifications (protocol)
- Memory specifications
- Regulatory compliance (EMC)
- Regulatory compliance (safety)
- Regulatory compliance (environmental)
- Regulatory Statements
- Cautions and Danger Notices
FIGURE 48 Installing a fan assembly
1. Fan assembly slot
2. Fan assembly
3. Captive screw
1. If replacing a fan assembly:
a. Using a Phillips screwdriver, unscrew the captive screw on the fan assembly.
b. Remove the fan assembly from the chassis by pulling the handle on the fan assembly out and away from the chassis.
c. Ensure that the replacement fan assembly has the same part number and airow label as the fan assembly being replaced.
2. If installing a new fan assembly into a slot covered with a ller panel:
a. Using a Phillips screwdriver, unscrew the captive screw on the ller panel.
b. Remove the ller panel.
3. Before opening the package that contains the new fan assembly, touch the bag to the switch casing to discharge any potential
static electricity. It is recommended that you wear an ESD wrist strap during installation.
4. Remove the fan assembly from the anti-static shielded bag.
NOTE
Do not force the installation. If the fan assembly does not slide in easily, ensure that it is correctly oriented before
continuing.
5. Holding the fan assembly level, guide it into the carrier rails on each side and gently push it all the way into the slot, ensuring
that it rmly engages with the connector.
6. When you are sure the fan assembly has properly engaged the connector, tighten the captive screw to secure the fan assembly
in the slot.
NOTE
The fans are controlled automatically by the device.
Inserting a new fan assembly
ExtremeSwitching SLX 9030 Hardware Installation Guide
94 9035691-02 Rev AD