Installation guide

S
UMMIT
H
AREWARE
I
NSTALLATION
G
UIDE
2-7
L
OGGING
I
N FOR THE
F
IRST
T
IME
4 At the password prompt, press [Return].
The default name, admin, has no password assigned. When you have successfully
logged on to the switch, the command-line prompt displays the name of the switch
(for example, Summit1) in its prompt.
5 Assign an IP address and subnetwork mask for VLAN default by typing
config vlan default ipaddress 123.45.67.8 255.255.255.0
Your changes take effect immediately.
6 Save your configuration changes so that they will be in effect after the next switch
reboot, by typing
save
For more information on saving configuration changes, refer to the ExtremeWare
Software User Guide
.
7 When you are finished using the facility, logout of the switch by typing
logout
After two incorrect login attempts, the Summit locks you out of the login facility.
You must wait a few minutes before attempting to log in again.
SummitInstall.book Page 7 Thursday, February 25, 1999 12:54 PM