Installation Guide
Table Of Contents
- Table of Contents
- Preface
- ExtremeSwitching 5520 Series Overview
- Port Partitioning
- Power Supplies for Use with Your Switch
- Expansion Modules
- Site Preparation
- Building Stacks
- Installing Your Switch
- Activating and Verifying the Switch
- Installing Expansion Modules
- Installing a V300 Virtual Port Extender
- Install a V300 Virtual Port Extender on a Wall
- Install a V300 Virtual Port Extender Under or on a Table Surface
- Install a V300 Virtual Port Extender in a VESA Mount
- Install a V300 in a Single Rack Mount
- Install a V300 in a Dual Rack Mount
- Install a V300 in a DIN Rail Mount
- Install a V300-8P-2T-W Model in a Single or Dual Rack Mount
- Installing a V300-8P-2T-W Model in a DIN Rail Mount
- Connecting the V300 Virtual Port Extender to Power
- Installing a V400 Virtual Port Extender
- Installing a Half-Duplex to Full-Duplex Converter
- Install a Versatile Interface Module in a 5520 Series Switch
- Installing a V300 Virtual Port Extender
- Replacing AC Power Supplies
- Replacing Fan Modules
- Monitoring the Device
- Technical Specifications
- ExtremeSwitching 5520 Series Technical Specifications
- V300 Virtual Port Extender Specifications
- V400 Virtual Port Extender Technical Specifications
- Half-Duplex to Full-Duplex Converter Technical Specifications
- 350 W AC Power Supplies Technical Specifications
- 715 W AC Power Supplies Technical Specifications
- 1100 W AC Power Supplies Technical Specifications
- 2000 W AC Power Supply Technical Specifications
- Power Cord Requirements for AC-Powered Switches and AC Power Supplies
- Console Connector Pinouts
- Safety and Regulatory Information
- Considerations Before Installing
- General Safety Precautions
- Maintenance Safety
- Fiber Optic Ports and Optical Safety
- Cable Routing for LAN Systems
- Installing Power Supply Units and Connecting Power
- Selecting Power Supply Cords
- Battery Notice
- Battery Warning - Taiwan
- EMC Warnings
- Japan (VCCI Class A)
- Korea EMC Statement
- Glossary
- Index
5520-VIM-4YE Versatile Interface Module
The 5520-VIM-4YE versatile interface module provides four 25-GbE (SFP28) MACsec capable ports.
Note
In VOSS, you must use the sys vim-speed command to set the speed to 10G or 25G for
5520-VIM-4YE. The default is 25G. A reboot is not necessary after setting the speed.
In EXOS, use the configure ports partition command with 4x25 or 4x10.
For information about the supported optical modules, refer to the most recent version of the Extreme
Optics website.
Figure 30: 5520-VIM-4YE Versatile Interface Module
Table 14: Port Numbers for Ports on the 5520-VIM-4YE Module
5520 Series 24-port models 5520 Series 48-port models VOSS (all models)
33-36 (EXOS) 57-60 on 48-port models (EXOS) VIM slot number=2
Interface names=2/1-2/4
Expansion Modules 5520-VIM-4YE Versatile Interface Module
ExtremeSwitching 5520 Series Hardware Installation Guide 35