Installation Instructions

Table Of Contents
VSP 4000 PSU Usage Part number
(order code)
*Note: The seventh character (?) of the switch order number must be replaced with the
proper letter to indicate desired product nationalization. See the following for details:
“A”: No power cord included.
“B”: Includes European “Schuko” power cord common in Austria, Belgium, Finland, France,
Germany, The Netherlands, Norway, and Sweden.
“C”: Includes power cord commonly used in the United Kingdom and Ireland.
“D”: Includes power cord commonly used in Japan.
“E”: Includes North American power cord.
“F”: Includes Australian power cord.
Supported optical devices
Use optical devices to achieve high bit-rate communications and long transmission distances.
The following section describes the supported optical devices on the VSP 4000 system.
Small form factor (SFP) pluggable transceivers
SFPs are hot-swappable input and output enhancement components designed for use with
Avaya products to allow gigabit Ethernet ports to link with other gigabit Ethernet ports over
various media types.
You can use various SFP (1Gb/s) and SFP+ (10Gb/s) to attain different line rates and reaches.
The following table describes the SFPs including the reach provided by various SFPs.
This table is informational only—not all Avaya Ethernet switching and routing products support
all the SFPs listed here.
For more information about SFP and SFP+ transceivers, including technical specifications and
installation instructions, see Installing Transceivers and Optical components on the Avaya
Virtual Services Platform 4000, NN46251-301.
Important:
The attainable cable length can vary depending on the quality of the fiber optic cable
used.
Table 3: Compatible SFPs
Hardware
Description Part number
1000BASE-T (RJ-45)
SFP
Gigabit Ethernet, RJ-45 connector
Range up to 100 m
AA1419043-E6
1000BASE-SX (LC) DDI 850 nm, Gigabit Ethernet, duplex LC
connector
Range up to 500 m
AA1419048-E6
Supported optical devices
Installation February 2014 21