Troubleshooting Guide

7. View the configuration to ensure it is correct:
show syslog [host <1–10>]
Example
Configure a UNIX system log host address to IPv4 address 47.17.143.52 and syslog host:
VSP-4850GTS-PWR+:1(config)#syslog enable
VSP-4850GTS-PWR+:1(config)#syslog host 7 address 1.1.1.1
VSP-4850GTS-PWR+:1(config)#syslog host 7 enable
VSP-4850GTS-PWR+:1(config)#show syslog host 7
Id : 7
IpAddr : 1.1.1.1
UdpPort : 514
Facility : local7
Severity : info|warning|error|fatal
MapInfoSeverity : info
MapWarningSeverity : warning
MapErrorSeverity : error
MapMfgSeverity : notice
MapFatalSeverity : emergency
Enable : true
SecureForwardingMode: none
Tcp Port : 1025
VSP-4850GTS-PWR+:1(config)#show syslog
Enable : true
Max Hosts : 5
OperState : active
header : default
Total number of configured hosts : 3
Total number of enabled hosts : 1
Configured host : 7 8 9
Enabled host : 7
Variable definitions
Use the data in the following table to use the syslog command.
Table 7: Variable definitions
Variable Value
enable Enables the sending of syslog messages on the device. The
default is disabled. Use the no operator before this
parameter, no syslog enable to disable the sending of syslog
messages on the device. The default is enabled.
Table continues…
Configuring a UNIX system log and syslog host
January 2017 Troubleshooting 47
Comments on this document? [e-mail]