Installation Instructions
Table Of Contents
- Contents
- Chapter 1: About this Document
- Chapter 2: New in This Document
- Chapter 3: Hardware Models for VSP 7200 Series
- Chapter 4: Preinstallation Checklist
- Chapter 5: Installing the Virtual Services Platform 7200 Series
- Installation checklist
- Installation fundamentals
- Electrostatic discharge
- Technical specifications
- Package contents
- Installing a power supply
- Removing a power supply
- Install a Fan Module
- LED state definitions
- Installing the switch in an equipment rack
- Cable Requirements for the VSP 7200 Series
- Installation and removal of transceivers
- Console port pin assignments
- 40GBASE-QSFP+ ports
- MACsec operational notes
- Viewing hardware information
- Chapter 6: Translations of safety messages
5. Use the following steps to attach the chassis rail to the chassis:
a. Orient the chassis rail with the thumbscrew lock towards the front and position the rail
over the standoffs on the chassis.
b. Slide the chassis rail to the rear until the rail locks into the standoffs.
c. Make sure the safety tab locks into place.
Installing the Virtual Services Platform 7200 Series
March 2020 Installing the VSP 7200 Series 60