Installation Instructions
Table Of Contents
- Contents
- Chapter 1: About this Document
- Chapter 2: New in This Document
- Chapter 3: Hardware Models for VSP 7200 Series
- Chapter 4: Preinstallation Checklist
- Chapter 5: Installing the Virtual Services Platform 7200 Series
- Installation checklist
- Installation fundamentals
- Electrostatic discharge
- Technical specifications
- Package contents
- Installing a power supply
- Removing a power supply
- Install a Fan Module
- LED state definitions
- Installing the switch in an equipment rack
- Cable Requirements for the VSP 7200 Series
- Installation and removal of transceivers
- Console port pin assignments
- 40GBASE-QSFP+ ports
- MACsec operational notes
- Viewing hardware information
- Chapter 6: Translations of safety messages
8. Use the countersink screws with the following steps to attach the extension bracket to the
rack rail:
a. Push the blue release lock up and slide the middle rail out as far as possible.
b. Note the order and position of how the components are installed. The extension bracket
(with the flat side down) goes on top of the rack rail and then the long rear bracket
slides into the extension bracket.
c. Orient the extension bracket over the holes in the rack rail.
Installing the switch in an equipment rack
March 2020 Installing the VSP 7200 Series 63