Installation Guide

39
安裝指南
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that permitted for successful communication.
The device could automatically discontinue transmission in case of absence of information to trans-mit, or
operational failure. Note that this is not intended to prohibit transmission of control or signaling information or the
use of repetitive codes where required by the technology.
In compliance with respective local regulatory law, Access Point software provides professional installers the
option to configure the antenna type and antenna gain for approved antennas.
This radio transmitter MODEL: AP-7562 has been approved by Industry Canada to operate with the antenna types
listed below with the maximum permissible gain and required antenna impedance for each antenna type
indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that
type, are strictly prohibited for use with this device.
Le présent émetteur radio MODEL: AP-7562 a été approuvé par Industrie Canada pour fonctionner avec les types
d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type
d'antenne.Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué,
sont strictement interdits pour l'exploitation de l'émetteur.
Refer AP-7562 Antenna Accessories on page 6 of this guide for a listing of the 2.4 and 5 GHz antennas initially
approved for use with the AP-7562.
5.9 CE 標誌和歐洲經濟區 (EEA ， European Economic Area)
在歐洲經濟區 (EEA) 內使用 2.4 GHz RLAN 時，具有下列限制：
• 最大發射功率為 100 mW EIRP，頻率範圍為 2.400 -2.4835 GHz
• 義大利：戶外使用需要使用授權。
5.10 符合性聲明
Extreme Networks特此聲明此無線電設備符合指令2011/65 / EU和1999/5 / EC或2014/53 / EU（
2014/53 / EU從2017年6月13日起取代1999/5 / EC）。
5.11 其他國家 / 地區
澳洲
於澳洲使用 5 GHz RLAN 時，頻帶限制為：5.50 - 5.65 GHz。