Installation Guide

2. Completely loosen the captive retaining screws and slide the installed option card or stacking
module out of the switch.
Figure 438: Removing a SummitStack Module
3. Carefully slide the replacement module or card into the switch (see Figure 439).
4. Align and tighten the captive retaining screws.
Figure 439: Installing a SummitStack Module
Replacing an XGM3/XGM3S Series Port Option Card in a Summit X460
Series Switch
Note
After you replace an XGM3-2sf port option card, you must reboot the switch before the ports
on the card will become operational.
Removing and Replacing Expansion Modules
Replacing an XGM3/XGM3S Series Port Option Card in a
Summit X460 Series Switch
Summit Family Hardware Installation Guide 505