RX722501HC Parts List 72 inch Steel Top Hutch shown on RX722519RC Model: RX722501HC 2 Extreme Tools, Inc. 740 Frontenac Rd Naperville, Illinois 60563 630.369.9303 www.ExtremeTools.
Step 1: Attach Slide Splicer Posts to Side Panels Step 2: Install Side Panels on Roller Cabinet a. Slide Splicer Post Assembly (#9) into bottom opening of the left-hand Side Panel Assembly(#2). a. Remove plastic end caps from the top of the trim located at the front corners of the roller cabinet. b. Line up hole in Splicer Post with hole in Side Panel. b. Slide end of splicer channel into opening where plastic end cap was located until side panel rests on top of MDF/Stainless Steel Top. c.
Step 3: Secure Side Panels Step 4: Install Back Panel a. Install one Hold-Down Bracket (#14) on each side using one flat washer (#16) and one M8 bolt (#15) for each side. a. Pull MDF board/Stainless Steel Top forward approximately 1/8” from Back Raised Edge (aka: Fence Rail.) b. Lift Back Panel into place behind the two side panels. Slide the bottom edge of the Back Panel between the MDF/Stainless Steel Top and rear fence rail of roller cabinet.
Step 5: Secure Back Panel & Set Shelf Height Step 6: Install Adjustable Shelf a. Line up the holes on the left-hand Back Panel Flange with the threaded inserts of the Side Panel. b. Secure using (6) screws (#11.) a. Locate the (2) open slots on each side of the shelf. Line up the open slots with the (4) threaded screws that were installed in Step 5d. Lay down shelf so that (4) open slots fit on top of the (4) screws. c. Repeat on for right-hand side panel. b. Tighten (4) screws. d.
Step 7: Attach Gas Struts to Lid Step 8: Install the Lid onto the body of the Hutch a. Lay the lid down on packaging material so that the front of the lid is face down. Be sure to use packaging material under the lid so that it does not get scratched or damaged. LID is HEAVY! LID INSTALLATION REQUIRES ASSISTANCE to LIFT and MAY REQUIRE the USE of MECHANICAL EQUIPMENT to PROPERLY POSITION! b. Locate the (2) openings near the Top Panel Stiffener. c.
Step 8: Secure Lid to Body of Hutch Step 9: Secure Gas Strut to Side of Hutch a. Use the Allen wrench (supplied with the parts) to drive the prethreaded M5-16mm Sock Head Screw (#4) into the round opening on the side of the lid. a. Prop open the lid so that it cannot fall. b. Install the male fitting on the piston end of the gas strut into the opening near the inside top of the side panel. b. Insert one plastic hole plug (#5) in each of the socket head screw openings. c.
Step 10: Install Power Strip with USB Ports (#7) a. Line up 4 holes on the Power Strip (#7) with 4 holes located toward the right on the face of the shelf front. b. Use Phillips screwdriver, (4) M4x10mm Machine Screws (#21) and (4) M4 LockNuts (#20) to secure power strip. FULLY ASSEMBLED EXTREME TOOLS RX SERIES HUTCH shown on RX SERIES ROLLER CABINET Step 11: Install Rubber Grommets a. Insert the Rubber Grommets (#8) in the openings toward the lower right and left sides of the Back Panel.