User Manual

The Extricom WLAN System User Guide 15
Table 1. Extricom EXSW-800/1200/2400 Switch Connectors
Connectors Description
Console Serial connector – only to be used by, or as instructed by Extricom
personnel for troubleshooting, support, or maintenance. Can be
accessed using a Null modem cable.
EXSW-800
LAN
EXSW-
1200/2400
LAN1, LAN2
RJ-45 connectors – used to connect the switch to the wired LANs. On
EXSW-1200/2400 these connectors provide redundancy and load
sharing between them.



LAN2 is not currently active pending future development.
WLAN RJ-45 connectors – used to connect Extricom APs to the switch.
-
Do not connect any device other than Extricom APs to
the WLAN ports.
These ports provide 802.3AF PoE compatible power.
Maximum current: 270 mA, 48 volts.
Table 2 describes the front panel LEDs of Extricom EXSW-800/1200/2400 switches.
Table 2. Extricom EXSW-800/1200/2400 Switch LEDs
LEDs Color Description
Power Green On/off
LAN, LAN1, LAN2
Link/Act Green


 On indicates connection to the LAN network


 Blinking indicates activity in the LAN network connection


 Off indicates no connection to the LAN network
EXSW-800
100M
Orange


 On – 100Mbps full duplex


 Off – 10Mbps
EXSW-
1200/2400
100/1000
Orange


 On – 100Mbps full duplex


 Blinking – 1000Mbps full duplex



1000Mbps is not currently active pending future
development.
WLAN
Link Green


 On indicates connection to the WLAN AP


 Blinking indicates activity over the connection to the WLAN
AP


 Off indicates no connection to the WLAN AP