User Guide DVI and HDMI® HDMI 101 Plus Cable Equalizer 68-1983-01 Rev.
Safety Instructions • English This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product enclosure that may present a risk of electric shock. Warning Power sources • This equipment should be operated only from the power source indicated on the product.
FCC Class A Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation.
Conventions Used in this Guide In this user guide, the following are used: TIP: A tip provides a suggestion to make working with the application easier. NOTE: A note draws attention to important information. CAUTION: WARNING: A caution indicates a potential hazard to equipment or data. A warning warns of things or actions that might cause injury, death, or other severe consequences.
Contents Introduction............................................................ 1 About the HDMI 101 Plus.................................... 1 Features............................................................... 1 Application Diagram............................................ 2 Panel Features, Connections, and Setup................................................................. 3 HDMI 101 Plus Front and Rear Panel Features and Connections................................................
HDMI 101 Plus • Contents vi
Introduction This user guide contains information about the Extron HDMI 101 Plus cable equalizer and describes the procedures for connecting and operating it. In this manual, the term “equalizer” refers to the HDMI 101 Plus cable equalizer. About the HDMI 101 Plus The HDMI 101 Plus is a compact, economical cable equalizer.
Application Diagram The following diagram shows a typical application for the HDMI 101 Plus. Long HDMI Cable 250' (76 m) MI HD R WE PO X V 12 MA 0.4A MI HD UT TP OU lus 1P 10 Short HDMI Patch Cable Extron DVD with HDMI Output HDMI 101 Plus Equalizer Display Figure 1.
Panel Features, Connections, and Setup This section describes the features and connections of the front and rear panels of the HDMI 101 Plus and how to set up the unit. HDMI 101 Plus Front and Rear Panel Features and Connections Front Panel Features and Connections 2 3 HDMI 101 Plus POWER 12V 0.2A MAX 4 1 HDMI OUTPUT HDMI INPUT Figure 2. a HDMI 101 Plus Front Panel Power and signal status LED — This LED is dual colored.
Input cable lengths The maximum input cable length is 250 feet (76 m) for a transmission rate of 165 MHz; a cable length of up to 200 feet (61 m) can be used for a transmission rate of 225 MHz. Longer cables may be used with a lower rate. High quality cable can increase the distance and rate of transmission. Other factors affecting the maximum transmission distance and frequency include the sensitivity of the input source and the display device.
d Power Connector — Plug the external 12 V power supply (provided with the unit) into this 2-pole captive screw connector. NOTE: The HDMI 101 Plus can draw power from the external power supply or, via the HDMI cable, from the input device (see “Powering Via the Input Source” on page 6). For optimum performance, Extron recommends that the power is taken from the external power supply. The figure below shows how to wire the connector.
Powering Via the Input Source For shorter distances, the HDMI 101 Plus can receive power from the input device via the 5 VDC signal on pin 18 of the HDMI cable (see the table on page 3). This eliminates the external power supply. However, for best unit performance, Extron recommends using the external supply. NOTES: • If the source does not adequately supply the +5 V power, an external power supply must be used.
Reference Information Specifications NOTE: *Appropriate HDMI to DVI-D cables or adapters are required for DVI signal input/output.
Mounting ��������������������������������������� Rack mountable with optional rack shelf kit Enclosure type �������������������������������� Metal Enclosure dimensions ��������������������� 1.0" H x 2.2" W x 3.0" D (1/8 rack wide) (2.5 cm H x 5.6 cm W x 7.6 cm D) (Depth excludes connectors.) Product weight ������������������������������� 0.4 lbs (0.
Mounting This section outlines the various options for mounting the HDMI 101 Plus. zz Tabletop mounting zz Rack mounting zz Under-desk mounting zz Through-desk mounting Tabletop Mounting Attach the four provided rubber feet to the bottom of the unit and place it in any convenient location.
Rack Mounting the HDMI 101 Plus The HDMI 101 Plus can be mounted on any of these optional Extron rack systems: RSF 123 — 3.5 inch deep, 1U universal rack shelf kit (part number 60-190-20) RSB 123 — 3.5 inch deep, 1U basic rack shelf (part number 60-604-21) RSU 126 — 6 inch deep, 1U universal rack shelf kit (part number 60-190-10) RSB 126 — 6 inch deep, 1U basic rack shelf (part number 60-604-11) RSU 129 — 9.5 inch deep, 1U universal rack shelf kit (part number 60-190-01) RSB 129 — 9.
Extron® Warranty Extron Electronics warrants this product against defects in materials and workmanship for a period of three years from the date of purchase.
Extron USA - West Extron USA - East Extron Europe Extron Asia Extron Japan Extron China Extron Middle East +800.633.9876 Inside USA/Canada Only +800.633.9876 Inside USA/Canada Only +800.3987.6673 Inside Europe Only +800.7339.8766 Inside Asia Only +81.3.3511.7655 +81.3.3511.7656 FAX +400.883.1568 Inside China Only +971.4.2991800 +971.4.2991880 FAX +1.714.491.1500 +1.714.491.1517 FAX +1.919.863.1794 +1.919.863.1797 FAX +31.33.453.4040 +31.33.453.4050 FAX +65.6383.4400 +65.6383.