User’s Guide VersaTools™ MSW 4V SDI Mini Serial Digital Interface Switcher 68-643-01 Rev.
Installation Introduction The Extron MSW 4V SDI is a four-input, two-parallel-output, mini SDI (serial digital interface) switcher (MSW). The MSW is a member of the Extron VersaTools™ line of basic distribution amplifiers, switchers, and associated video accessories. The MSW switches among up to four SMPTE-259M serial video SDI inputs on female BNC connectors and outputs two identical equalized and re-clocked SDI outputs on female BNC connectors.
Installation For furniture mounting, drill 3/32” (2 mm) diameter pilot holes, 1/4” (6.3 mm) deep in the mounting surface at the marked screw locations. 4. POWER 1 For furniture mounting, insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until just less than 1/4” of the screw protrudes. 5. For furniture mounting, align the mounting screws with the slots in the brackets and place the MSW against the surface, with the screws through the bracket slots. 6.
Connections To verify the polarity before connection, check the no load power supply output with a voltmeter. switches to the highest numbered input with active SDI signals. When unlit, the switch is in normal (manual switch) mode. Alternatively, an Extron P/S 100 Universal 12VDC Power Supply can power up to ten MSWs or other Extron 12V DC devices using only one AC power connector.
Contact closure pin configurations See switcher’s label. General Power ............................................. 100VAC to 240VAC, 50/60 Hz, 6 watts, external, autoswitchable; to 12VDC power supply. Temperature/humidity .............. Storage -40° to +158°F (-40° to +70°C) / 10% to 90%, non-condensing Operating +32° to +122°F (0° to +50°C) / 10% to 90%, non-condensing Rack mount ...................................