User’s Manual CVEQ1, CVEQ1 WM, CVEQ1 AAP www.extron.com Extron Electronics, USA Extron Electronics, Europe Extron Electronics, Asia Extron Electronics, Japan 1230 South Lewis Street Anaheim, CA 92805 USA 714.491.1500 Fax 714.491.1517 Beeldschermweg 6C 3821 AH Amersfoort The Netherlands +31.33.453.4040 Fax +31.33.453.4050 135 Joo Seng Road, #04-01 PM Industrial Building Singapore 368363 +65.6383.4400 Fax +65.6383.4664 Daisan DMJ Building 6F 3-9-1 Kudan Minami Chiyoda-ku, Tokyo 102-0074 Japan +81.3.
Precautions Safety Instructions • English This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product's enclosure that may present a risk of electric shock. Caution Read Instructions • Read and understand all safety and operating instructions before using the equipment.
Table of Contents Chapter 1 • Introduction .......................................................... 1-1 About the CVEQ1, CVEQ1 WM, and CVEQ1 AAP .... 1-2 Features ...................................................................................... 1-2 Chapter 2 • Installation, Setup, Operation ................. 2-1 Installation Overview .......................................................... 2-2 UL Requirements ....................................................................
Table of Contents, cont’d CVEQ1, CVEQ1 WM, CVEQ1 AAP 1 Chapter One Introduction About the CVEQ1, CVEQ1 WM, and CVEQ1 AAP Features ii CVEQ1, CVEQ1 WM, CVEQ1 AAP • Table of Contents
Introduction About the CVEQ1, CVEQ1 WM, and CVEQ1 AAP The Extron CVEQ1 is a one-input, one-output, composite video line driver. It features a 30 MHz (< ±0.5dB) video bandwidth. It accepts one composite video input on a female BNC connector and one stereo audio input on a pair of female RCA connectors. One female BNC connector provides equalized video output, and a five-pole captive screw connector provides for stereo audio output.
Installation, Setup, Operation Installation Overview CAUTION Installation and service must be performed by authorized personnel only. The CVEQ1 AAP and CVEQ1 WM must be used with UL approved electrical boxes. See “UL Requirements”, page 2-3. B. Disconnect the input and output devices’ power. C. For the CVEQ1 WM, secure the faceplate onto the UL-approved electrical wall box in the wall or furniture.
Installation, Setup, Operation, cont’d CVEQ1, CVEQ1 WM, CVEQ1 AAP • Installation, Setup, Operation CVEQ1, CVEQ1 WM, CVEQ1 AAP • Installation, Setup, Operation
Installation, Setup, Operation, cont’d Rear/Bottom/Side Panel Features and Cabling CVEQ1 Rear Panel CVEQ1 AAP Bottom Panel AUDIO OUTPUT VIDEO OUTPUT POWER 2 3 R J6 1 1 J2 L L 3 R 1 R L 1 2 1 J2 CVEQ1 WM Side Panel 1 1 L L R Tip See Caution Sleeve (s) Tip See Caution CAUTION R R Unbalanced Audio Output L 2 Audio output connector — Cable an audio device to the line driver via this female 5-pole captive screw connector. Wire the male connector as shown below.
Installation, Setup, Operation, cont’d Top/Side Panel Features and Adjustments Power Connector CVEQ1 AAP/CVEQ WM Rear Panel J2 1 The CVEQ1 WM and CVEQ1 AAP have a female captive screw connector instead of a jack for connecting an external Positive power source. Wire the N/C power connection as shown Negative at right.
Installation, Setup, Operation, cont’d changes the level and peaking of the output signal to compensate for capacitance caused by up to 1000 feet (304.8 meters) of Extron SHR cable. Use a small, flat-blade screwdriver to rotate this control. View the display and select the setting that gives the sharpest picture.
Installation, Setup, Operation, cont’d Mounting the CVEQ1 WM The CVEQ1 WM must have output cables connected before it is installed in a wall or furniture. Secure the CVEQ1 WM to wall box as shown below.
Specifications, Part Numbers, Accessories Specifications Audio output Video Gain ................................................... Adjustable .... 0.5V to 2.0V ±10% (-6dB to +6dB) with input at 1 volt Equalization/peaking gain ........... 4.5dB max. @ 8 MHz Bandwidth ........................................ 30 MHz (< ±0.5dB) Differential phase error .................. 1º, 3.58 MHz Differential gain error .................... 0.07%, 3.58 MHz Video input Number/signal type ......................
Specifications, Parts, and Accessories, cont’d Compliances .................................... CE, FCC Class A MTBF ................................................. 30,000 hours Warranty ........................................... 3 years parts and labor CVEQ1, CVEQ1 WM, CVEQ1 AAP Specifications are subject to change without notice. (7.
Dimensions and Templates Dimensions Cut-out Template The dimensions drawing is not 100% of the actual size. ø 0.156 THRU WITH ø 0.290 X 82˚ C'SINK (2 PLACES) CVEQ1 WM cut-out template 2.790 1.465 1.395 0.000 ø 0.120 THRU R 0.250 (4 PLACES) 4.500 3.890 3.700 R 0.060 (TYP) 0.100 The medium grey area indicates the cut-out area (4.13"H x 2.3"W) for a regular electrical wall box. 3.410 3.160 ø 0.530 THRU VIDEO IN 2.720 L AUDIO IN 2.024 R AUDIO IN 1.433 ø 0.440 THRU (2 PLACES) C'BORE 2.
Dimensions, Templates, cont’d B-4 CVEQ1, CVEQ1 WM, CVEQ1 AAP • Dimensions, Templates