- Extron Electronics CVEQ1, CVEQ1 WM, CVEQ1 AAP User's Manual

CVEQ1, CVEQ1 WM, CVEQ1 AAP • Installation, Setup, Operation
CVEQ1, CVEQ1 WM, CVEQ1 AAP • Installation, Setup, Operation
Installation, Setup, Operation, cont’d
GAIN EQUALIZE
1 2 1 2
1
2
CVEQ1
Top Panel
CVEQ1 AAP
Top Panel
CVEQ1 WM
Side Panel
Adjust the gain and
equalization before
installing the CVEQ1 AAP
or CVEQ1 WM into a wall
or furniture, as the gain and
equalization adjustment
controls will be inaccessible
after installation.
produces a gain adjustment ranging from -6dB
to +6dB. Select the setting that gives the best
picture brightness.
You can judge the adjustment visually by
looking at the display. For a more precise
setting you can use an oscilloscope or a
waveform monitor connected to the far
end of the output cable, and adjust the
gain so that the level at the waveform
monitor is 100 IRE.
2
Equalization adjustment control
(Equalize) — To adjust the output level
and peaking to get a sharp picture, rotate
this two-turn potentiometer. This adjustment
1
Gain adjustment control —
This control adjusts picture
brightness by compensating
for signal amplitude loss
caused by cable resistance.
To adjust the output gain,
view the display while using
a small, flat-blade screwdriver
to rotate this two-turn
potentiometer. This control
Top/Side Panel Features and Adjustments
2-9
VIDEO INPUT
GAIN
EQUALIZE
AUDIO INPUT
CVEQ1
L
R
Gain
Equalize
2-8
CVEQ1 AAP/CVEQ WM
Rear Panel
Power Connector
J2 1
Positive
Negative
N/C
The CVEQ1 WM and CVEQ1 AAP have a female captive screw
connector instead of a jack
for connecting an external
power source. Wire the
power connection as shown
at right.