User's Manual

Front Panel Indicators
The front panel of the IPL T CR48 has several indicator LEDs that show the current status of
communications to and from the unit. A Reset button (
b
) is also available from the front
panel, in a small recess next to the Power LED.
42
31
RELAY
86
75
IPL T CR48
R
42
31
INPUT
100
LINK
ACT
7
6
1
3
2
4
5
Figure 8. IPL T CR48 Front Panel
a
Power LED — A green LED lights to indicate that the unit is receiving power.
b
Reset button — Recessed multiple function Reset button. See Resetting the
Controller later in this section.
c
Input LEDs — A green LED lights to indicate that the port is active.
d
Relay LEDs — A green LED lights to indicate that the relay is closed and activated.
e
100 LED — A green LED lights to indicate that the connection speed is 100 Mbps. If the
LED is not lit, the connection speed is 10 Mbps.
f
LINK LED — A green LED lights to indicate that the unit is connected to an active
network.
g
ACT LED — A yellow LED lights to indicate that data is being sent or received.
Resetting the Controller
There are four reset modes (numbered 1, 3,4, and 5 for the sake of comparison with other
Extron IPL products) available by using the Reset button (
b
) on the front panel. The Reset
button is recessed, so use of a pointed stylus, ballpoint pen, or Extron Tweeker is suggested.
CAUTION: Review the reset modes carefully. Use of the wrong reset mode may result in
unintended loss of flash memory programming, reassignment of ports, or a
unit reboot.
IPL T CR48 • Installation and Operation 8